User manual ZANKER ZKS5453IE

[. . . ] Geschirrspüler Dishwasher ZKS 5453 IE D GB Bedienungsanleitung Instruction book Seite 2 page 19 Contents Safety instructions Disposal Economical and ecological dishwashing Installation instructions Building-in Levelling Fixing to the adjacent units Water supply connections Water inlet hose with safety valve Water outlet hose connection Electrical connection Description of the appliance The control panel Audible signals Prior to using for the first time The water softener Filling with dishwasher salt Rinse aid In daily use Loading cutlery and dishes The lower basket The cutlery basket The upper basket Adjusting the height of the upper basket Use of detergent Different kinds of detergent Washing programmes Starting a washing programme 20 20 20 21 21 21 21 21 21 22 22 23 24 24 25 25 26 26 27 27 27 27 28 28 28 29 30 31 Maintenance and cleaning Cleaning the filters Prolonged periods of non-operation Frost precautions Moving the machine Something not working Service and spare parts Hints for test centres 32 32 32 32 32 33 34 35 Technical specifications Dimensions Width Height Max depth Max depth with open door 44. 6 cm 81. 8 - 87. 8 cm 55. 5 cm 114 cm Electrical connection: Voltage Overall power Fuse Water supply pressure Information on the electrical connection is given on the rating plate on the inner edge of the dishwasher's door. Minimum Maximum 50 kPa (0. 5 bar) 800 kPa (8 bar) 9 place settings Capacity This appliance complies with the following E. E. C. Directives: - 73/23 or 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 or 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. 19 Safety instructions It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. [. . . ] All other types of salt not specifically designed for use in a dishwasher, especially table salt, will damage the water softener. Only fill with salt just before starting one of the complete washing programmes. This will prevent any grains of salt or salty water, which may have been spilt, remaining on the bottom of the machine for any period of time, which may cause corrosion. Rinse aid Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying. The dispenser, which is positioned inside the door, holds about 110 ml of rinse aid, which is sufficient for between16 and 40 dishwashing cycles, depending upon the dosage setting. Filling with rinse aid 1. The maximum level for filling is indicated by "max". To fill: 1. Open the door, remove the lower basket and unscrew the cap of the salt container by turning it anticlockwise. Pour 1 litre of water inside the container (this is necessary only before filling with salt for the first time). Using the funnel provided, pour in the salt until the container is full. Replace the cap making sure that there is no trace of salt on the screw thread or on the gasket. Replace the cap tightly turning it clockwise until it stops with a click. Ensure that the lid is closed after every refill. Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during the next wash. This would damage the appliance. The salt container will require topping up periodically. You are reminded of this by the salt indicator light on the control panel which comes on when the salt has finished. The salt indicator light on the control panel can remain illuminated for 2-6 hours after the salt has been replenished, assuming the dishwasher remains switched on. If you are using salts that take longer to dissolve then this can take longer. Do not worry if water over flows from the unit when filling with salt, this is quite normal. Adjusting the dose According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (position 1 minimum dosage, position 6 maximum dosage). Increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce it if there are sticky whitish streaks on the dishes or a bluish film on glassware or knife blades. Top up the rinse aid when the indicator (B) becomes clear. 26 In daily use q Check if it's necessary to refill with dishwasher salt or rinse aid Load cutlery and dishes into the dishwasher. Start the wash programme. Loading cutlery and dishes Sponges, household cloths and any object that can absorb water may not be washed in the dishwasher. q q q q q Before loading the dishes, you should: - Remove large left-overs. - Soften remnants of burnt food in pans When loading the dishes and cutlery, please note: - Dishes and cutlery must not impede the rotation of the spray arms . with the opening downwards so that water cannot collect in the container or a deep base. - Dishes and items of cutlery must not lie inside one another, or cover each other. [. . . ] Check the water drain hose connection. Anti-flood device is activated. Close the water tap and contact your Service Force Centre. Once the checks have been carried out, press the programme selection/cancel button and close the dishwasher's door. The programme will continue from the point at which it was interrupted. For other combinations of fault codes not described in the above chart, please contact your local Service Force Centre. . . . there are problems when operating the dishwasher Malfunction Possible cause The dishwasher door has not been properly closed. There is a whistling noise during washing The whistling is not a cause for concern. [. . . ]