User manual ZANKER ZKM3116KF

[. . . ] Using a standard or Phillips screwdriver, tighten the tension clamps evenly starting at the centre and moving diagonally, until the built-in rim is tight on the worktop. Do not use an electric or pneumatic screw driver without an adjustable safety clutch!11. 1Nm). Fig. 1 Seal Ceramic Worktop Bracket 11 Electrical connection The electrical connection of the ceramic hob to the specially provided built-in switch box and to the built-in range should only be carried out by a trained technician. Connect cable-plug with appropriate receptacle fixed on range or controlbox. [. . . ] Futhermore attention should be paid to the assembly instructions for the built-in switch box or oven with which the hob is connected!If the hob is operated from a switch box then it is necessary to have an intermediate bottom to ensure protection against accidental contact! min. 50 mm The distance between the underside of the hob and the furniture beneath must be at least 20 mm. Arrangements of hob - built - in oven/switch box may be looked-up in a special table which is an appendix to these instructions. Before installation and operation of the appliance the range of possibilities for combining the hob with the oven /switch box is to be checked by referring to the appropriate instructions for installation and operation. 20 mm min. 50 mm 20 mm Using other hobs than those of the ZANKERBrand excludes any liability. If these regulations are not observed all given approvals of test institutes are void. Important for the disassembly of the hob The supply of mains current to the appliance must be cut off (for example by unscrewing the safety devices). 12 Before the first use Clean your ceramic hob carefully before its first use. When you use the ceramic hob for the first time it can temporarely emit an odeur caused by a vaporation of water in the isolation. Description of appliances ZMK 3118 KX 1. Warming plate Ø Ø Ø Ø 210/120 mm 145 mm 170x256 mm 145 mm 2100 W 2 1200 W 2200 W 1200 W 120 W 3 6 1 5 5. Residual heat indicator 4 l O 13 Cooking zones The cooking zones are indicated by markings on the ceramic top. Sugar, plastic or kitchen foil remains should immediately be scraped off the hot cooking zone with a scraper. If the cooking zone cools down without being cleaned it could lead to fissures and cracks in the ceramic surface. Never use aggressive detergents or scouring powder and sponges with abrasive surfaces. Caution: As soon as any crack in the heating surface becomes visible, disconnect the appliance immediately from the supply. 15 Maintenance Ceramic hobs are treated and cleaned the same way as glass. Never use aggressive detergents or sponges with abrasive surface. Cleaning after each use Slight, not burnt soiling has to be wiped off with a damp cloth without using detergents. These heavy stains can not be wiped off easily by the first attempt and sometimes not even with a special detergent. Afterwards wipe off the ceramic hob with a damp cloth. Stain removal Light metallic stains (aluminium remains) can be removed from the cooled down cooking zone with a special detergent. Calcareous deposits (caused by overboiling water) can be removed with vinegar or a special detergent. Removal of sugar, sugar-containing food, plastic objects or kitchen foil The cooking zone involved must not be turned off! [. . . ] Removal of sugar, sugar-containing food, plastic objects or kitchen foil The cooking zone involved must not be turned off!The remains have to be scraped off the hot cooking zone immediately with a scraper. The cooking zone can be switched off after the removal of the soiling. The mentioned detergents are available in super-markets, electrical shops, drug stores, grocery stores and kitchen studios. [. . . ]