User manual ZANKER ZKK9417K

[. . . ] Care must be taken to ensure that the appliance does not stand on the electrical supply cable. The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. Manufacturers' storage recommendations should be strictly adhered to. During normal operation, the condenser and compressor at the back of the appliance heat up considerably. [. . . ] Fasten the appliance with 4 screws provided in the kit included with the appliance. Fig. 2: Attention: keep ventilation openings clear of obstruction. 50 mm min. cm 200 2 Press in the joint covers between the appliance and the kitchen furniture. Fig. 5 D526 Push appliance into housing until stop strip (A) touches the kitchen unit. Fig. 3 A D724 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 6 D023 B D726 43 Position the runners (A) at the top and bottom of the inside of the kitchen unit as shown in Fig. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. 7 In case of side fixing of the appliance, it will be sufficient to loose the screws fixing the bracket (E) and to position it as shown in Fig. 10 50mm A 20m PR166 E m D735 E Open both the appliance door and that of the kitchen unit to approx. Hold the doors of the appliance and the unit together and mark the holes. Fig. 8 8mm PR167 Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. Fig. Pilot light Use of the freezer Operation Insert the plug into the wall socket. Turn the thermostat knob, clockwise, beyond the «O» (STOP) position. The pilot light will light up, indicating that the appliance is in operation. To stop the appliance, turn the thermostat knob to position «O». Fast freezing To start fast-freezing food, turn the knob towards «S». Pilot light (D) will come on. Warning light Warning light (C) lights up when the temperature inside the freezer compartment has increased to a value which jeopardizes the long-term storage of food in the compartment. When the appliance is switched on for the first time or when food is placed in the compartment for freezing, it is normal for this light to remain on until the temperature has reached the level required for correct storage. Temperature regulation The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: room temperature; how often the door is opened; the quantity of food stored; location of appliance. Important If there is a power failure when food is in the freezer, do not open the door of the freezer compartment. [. . . ] Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out as follows: Do not use metal tools to remove the trays when they are stuck-frozen inside the compartment. 48 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. Warning This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. Interior light The light bulb inside the refrigerator compartment can be reached as follows: unscrew the light cover securing screws; unhook the moving part by pressing it as shown in the figure. If the door is open and the light does not come on, check that the bulb is properly screwed in; if it still does not work, replace the bulb with one of the same power. [. . . ]