User manual ZANKER ZKH7629X

[. . . ] Specific installation instructions for the installer are given in this booklet. appliance door and the surrounding parts are warmed up to a very high temperature. Be careful and keep children away from the appliance while you are using it. When you connect other appliances to a plug near the oven, check carefully that the wire does not touch warm parts of the oven and does not get taken in the oven door. [. . . ] Normal short pastry dough should be cooked in a mould or tin for 2/3 of total cooking time required and then garnished as desired before being cooked completely. Clearly, the remaining cooking time depends on the type of garnish used (jam, fruit, etc. ). Care should be taken to ensure that any dough and cake mixes are of the right consistency since an unduly moist mix lengthens cooking time unnecessarily. The raw dough or mix should therefore be fairly difficult to detach from the spoon or beater. For cooking meat and fish Meat cooked in the oven should weigh at least 1 kg to prevent it from becoming too dry during cooking. well cooked on the outside but extremely juicy inside, requires high-temperature cooking (200-220°C). White meat, poultry and fish instead require low-temperature cooking (150-175°C). The ingredients for the accompanying sauce or gravy should be put in the baking pan at the very beginning only when cooking times are short. Otherwise they should be added during the last half hour. A simple way of checking whether meat is done or not is to press it with a spoon; if the meat does not yield under this pressure it means that it is done to a turn. In the case of roast beef and fillet steaks, the inside of which should remain fairly pink in color, cooking times must be short. The meat can be cooked in a baking pan or else directly on the shelf - in this case a dripping pan must obviously be placed underneath the shelf to collect the juice. Directives: 73/23 - 90/683 (Low Voltage Directive); 89/336 (Electromagnetical Compatibility Directive); 93/68 (General Directives) and subsequent modifications. Replacing the oven light Disconnect the appliance from its power supply point. Unscrew the light bulb and replace it with a new heat-proof bulb (300°C) having the following features: - Operative tension: 230 V (50 Hz); - Power: 25 W; Fitting: E 14. The green & yellow ground wire must not be interrupted by the switch and it should be 2- Fig. 6 FO 0330 230V 3~ 12345 L1 L2 L3 PE 12345 L1 N 12345 L1 L2 N 12345 L1 L2 L3 N PE 230V 1~ 400V 2N~ PE 400V 3N~ Fig. After connecting the supply cable to the terminal board, secure it with a junction clamp. Electrical connection with the hob This oven can be connected to hobs indicated in the paragraph "Technical data". The socket for connecting the hob is located at the top of the oven cabinet. The hobs come complete with connecting leads for the hot plates/heat areas and ground cable; these leads feature plug-in connectors. Connection of the hob to the oven is carried out by plugging-in these connectors to the corresponding oven socket. The plug-to-socket connection design is such as to prevent possible wrong plugging-ins. The Manufacturer disclaims any liability in case these accident-preventing rules are not observed. 52 Building-in To ensure correct operation of the built-in assembly, the kitchen cabinet and the recess for the built-in appliance must have suitable dimensions. When the appliance is fitted-in, there must be no open spaces left and it must be closed on all sides by the kitchen furniture to prevent the possibility of inadvertently touching "live" (current carrying) parts of the oven. [. . . ] In accordance with provisions laid down in paragraphs 2 to 15, we will remedy free of charge any defect that occurs within 24 months from the date the appliance is delivered to the first end user. These guarantee terms do not apply in the event of use for professional or equivalent purposes. Performing the guarantee means that the appliance is returned to the condition it was in before the defect occurred. So as to avoid more severe damage, the defect must be brought to our attention immediately. [. . . ]