User manual ZANKER ZKD4050B

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual ZANKER ZKD4050B. We hope that this ZANKER ZKD4050B user guide will be useful to you.


ZANKER ZKD4050B : Download the complete user guide (262 Ko)

You may also download the following manuals related to this product:

   ZANKER ZKD4050B (286 ko)
   ZANKER ZKD4050B (256 ko)
   ZANKER ZKD4050B (251 ko)
   ZANKER ZKD4050B (264 ko)

Manual abstract: user guide ZANKER ZKD4050B

Detailed instructions for use are in the User's Guide.

[. . . ] Isolate the appliance from the power supply and turn off the water supply after use. Care should be taken when cleaning the bottom door seal and hinge area as any exposed metal edges may cut if care is not taken. This product should be serviced by an authorised Service engineer, and only genuine spare parts should be used. Under no circumstances should you attempt to repair the machine yourself. [. . . ] Glasses with long stems can be placed upside down in the raised cup racks. Light items (plastic bowls etc. ) should be loaded in the upper basket and arranged so they do not move. US63 Before closing the door, ensure that the spray arms can rotate freely. Adjusting the height of the upper basket If washing very large plates (over 27 cm and up to 31 cm in diameter) you can load them in the lower basket after moving the upper basket to the higher position. Move the front runner stops (A) of the upper basket outward and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. RC01 A When the top basket is in the higher position it will only take plates up to 20 cm in diameter and you will not be able to use the raised cup racks. After loading your machine always close the door, as an open door can be a hazard. 32 CES27en Use of detergent Only use detergents specifically designed for use in dishwashers. As all detergents are not the same, you should consult the instructions on the packet. If the programme has a prewash add the required detergent over the lid of the dispenser. DE17 Min = 15 g Max = 30 g D If using detergent in tablets proceed as follows: 1. For all programmes with prewash; place a portion of a further tablet on the lid of the detergent dispenser. Insufficient quantities of detergent will produce poor washing results, whereas an excessive amount of detergent will not improve washing results and is also wasteful. Using no more than the correct amount also contributes to reducing pollution. DE02 Compact detergents with enzymes In these compact powders the environmentally unfriendly components have been replaced by natural enzymes and other more biodegradable substances. The enzymes deploy their full dirt dissolving power at a temperature as low as 50°C. By choosing the "Bio" programmes you can therefore achieve the same cleaning results that would otherwise be achievable only with 65°C programmes and conventional detergents. These new compact powders are generally phosphate-free. 33 M M IN AX DET02en Hints and tips To save energy Place dishes in the machine immediately after every meal and wait until the dishwasher is full before washing. Leave the door ajar to prevent the formation of any unpleasant smells. Leave the inside of the machine clean. Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. Moving the machine If you have to move the machine (moving house etc. . . . ): 1. Avoid over tilting the machine during transportation. 38 MAN03en Something not working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Force Centre, please carry out the checks listed below. Symptom The machine will not start q q q Solution The door has not been properly closed. Dishes are rattling against each other, refer to "Loading your machine". The washing programme selected is too gentle. The machine does not fill with water q q q q The filters are blocked The spray arms are not rotating The dishwasher will not drain q q q q q q The machine is noisy q q The door is difficult to close Visible lime deposits or white film on the dishes The dishes are not quite dry The dishes are not clean (poor wash) q q q q q q q q q q q q q q 39 RIM05en If after all these checks, the problem persists, contact your local Service Force Centre, quoting the model and serial number. This information can be found on the rating plate located on the right hand side of the dishwasher door (see picture). Protection against flooding In order to prevent water floods, the machine has been provided with two additional devices, having the following characteristics: 1. The device comes into operation as a result of any damage to the water inlet hose and stops the water inflow. In the bottom of the machine: the device comes into operation as a result of any water leaks in the machine and it functions only with the machine on. . . . . . . . . RA01 Service and spare parts This product should be serviced by an authorised Service engineer, and only genuine spare parts should be used. [. . . ] The drain hose can face either to the right or left of the dishwasher Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water. If you use a drain hose extension it must be no longer than 2 metres and its internal diameter must be no smaller than the diameter of the hose provided. min 30 cm max 100 cm COL06en Ø 18 CS13 Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided. The sink plug must not be in place when the machine is draining as this could cause the water to siphon back into the machine. CS14 + 2 m max Electrical connection Before plugging the appliance into the wall socket, make sure that: 1. The mains voltage corresponds to the voltage given in the "Technical specifications". [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE ZANKER ZKD4050B




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual ZANKER ZKD4050B will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.