User manual ZANKER ZDC67550W

[. . . ] 125987350. qxp 2007-01-09 15:02 Page 1 user manual Tumble Dryer ZDC 67550W 125987350. qxp 2007-01-09 15:02 Page 2 125987350. qxp 2007-01-09 15:02 Page 3 electrolux 3 Welcome to the world of Electrolux Thank you for choosing a first class product from Electrolux, which hopefully will provide you with lots of pleasure in the future. The Electrolux ambition is to offer a wide variety of quality products that make your life more comfortable. Please take a few minutes to study this manual so that you can take advantage of the benefits of your new machine. We promise that it will provide a superior User Experience delivering Ease-of-Mind. [. . . ] (Only use those products which are declared as suitable for the drier by the manufacturer; please observe the manufacturer's instructions for use. ) GB Special Synthetics Easy iron Delicate Buzzer Time Special Jeans Dryness Cotton Delicate Cupboard dry Buzzer Time Special Cooling Cotton and linen Synthetics Buzzer Max Max Max Max Max Cottons load: Synthetics load: Time load: Special Mix load: Special Jeans load: 7 kg 3 kg 1 kg 3 kg 7 kg 125987350. qxp 2007-01-09 15:02 Page 16 16 electrolux programme information Programme information Objective Implementation Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to geographical locations thus varying its conductivity values. Relevant variations of the conductivity of the water compared to those prefixed by the factory could slightly influence the residual humidity of the laundry at the end of the cycle. Your dryer allows you to regulate the sensitivity of the drying sensor based on conductivity values of the water by using the following procedure. To access adjustment mode: Adjusting Adjusting the level of conductivity: the level of conductivity Press the START/PAUSE button sequentially: the level of conductivity is indicated by the phase pilot lights, which light in various combinations as follows: LED lit Conductivity Low Medium High 1. Press the buttons down until the pilot lights above each ones begin to flash and one of the pilot lights indicating the drying phase lights Empty Tank, Filter and Condenser remains it. Approximate value µS/cm < 300 300-600 >600 Empty Tank Filter Condenser Memorizing the new setting: Normally, the appliance is factory-set to the highest level; however, certain models may be configured differently. Simultaneously press the buttons DRYNESS and START. Press the buttons down until the pilot lights above each ones stop flashing and the buzzer sounds. Off = Cancelling/ OFF To reset a programme and to switch off the machine turn the selector dial to Off. Now can a new programme be selected. 125987350. qxp 2007-01-09 15:02 Page 17 care and cleaning electrolux 17 Care and cleaning GB You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. External cleaning Use only soap and water and then dry The filter in the inner door must be removed for cleaning. thoroughly. Important: do not use methylated spi`rit, diluents or similar products. . Cleaning the door Clean periodically the interior part of the door to remove any fluff from the seals around the filter. After a while, a withish patina due to detergent residue on laundry forms on the filters. Remove the filter in the door opening as per picture (it can be positioned with the tooth facing to the left or to the right). Cleaning the filters Your dryer will only function well if the filters are clean. The filters collect all the fluff which accumulates during drying and they must therefore be cleaned at the end of each programme, before removing the laundry, with a damp cloth. The light Filter is on to remind you this operation. 125987350. qxp 2007-01-09 15:02 Page 18 18 electrolux care and cleaning Do not use the appliance without filters. Cleaning the condenser unit Clean the condenser when light Condenser comes on. The condenser is situated at the lower part of the cabinet behind a small door. During the drying cycle or at the end, it is normal for water to be present on the surface of the condenser insertion. Clean it with a brush and rinse it under the shower if necessary. Clean the rubber seal round the condenser cabinet and in the inner part of the small door with a damp cloth. . Do not use pointed objects or utensils to clean the spaces between the plates, as this could damage the condenser and make it permeable. Re-fit the condenser, turn the red stops upwards and close the door. Important! To pull out the condenser, first turn the two red stops downwards and then remove the condenser unit holding it at the handle. Do not use this appliance if the condenser has not been fitted. Emptying the water reservoir Water extracted from the laundry condenses inside the machine and is collected in a reservoir. The reservoir must be emptied after each drying cycle to ensure efficient operation when the machine is next used. The pilot light Empty Tank reminds you this operation. 125987350. qxp 2007-01-09 15:02 Page 19 care and cleaning electrolux 19 Handy tip: Proceed as follows: · Open the small door at the lower part of the cabinet · Turn the yellow stop upwards · Pull out the reservoir · Open the small cover and let water flow down · Close the small cover and re-insert correctly the reservoir · Push it until it clicks and turn the yellow stop downwards to lock firmly it · Close the small door and press the START/PAUSE button again to allow the programme to continue. The condensed water may be used in a steam iron or to top up a battery, etc. Cleaning the air intake grille Using a vacuum cleaner remove the fluff from the air intake grille at the back of the appliance. GB Cleaning the drum When your laundry does not reach the desired degree of dryness, in other words, when it turns out either too dry or too damp, we advise you to clean the inside of the drum with a cloth soaked with vinegar. This will eliminate the slight patina that has formed in the drum (due to residues of detergent and softeners used in the washing, and to the lime contained in the water), which prevents the probes from detecting the correct degree of dryness. If this is not done the pilot light Empty Tank comes on during next drying and the programme stops, leaving the laundry damp. After emptying and inserting the reservoir the START-button has to be depressed again to allow the programme to continue. 125987350. qxp 2007-01-09 15:02 Page 20 20 electrolux something not working Something not working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. [. . . ] Applying the guarantee is subject to the consumer providing proof of purchase showing the purchase and/or delivery date. The guarantee will not apply if damage caused to delicate parts, such as glass (vitreous ceramic), synthetic materials and rubber, is the result of inappropriate use. The guarantee cannot be called on for minor faults that do not affect the value or the overall reliability of the appliance. The statutory warranty does not apply when defects are caused by: ­ a chemical or electrochemical reaction caused by water, ­ abnormal environmental conditions in general, ­ unsuitable operating conditions, ­ contact with harsh substances. [. . . ]