User manual ZANKER ZCM1030X

[. . . ] ELECTRIC DOUBLE OVEN AND GRILL WITH GAS HOB ZCM 1030 X ZCM 1031 X INSTRUCTION BOOKLET For your safety Warning: You must read these warnings carefully before installing or using the appliance. If you need assistance, contact our Customer Services Department on 08705 727727. The product should only be used for its intended purpose which is for the cooking of domestic foodstuffs. Under no circumstances shouid any external covers be removed for servicing or maintenance except by suitably qualified personnel. [. . . ] Setting error A setting error is made if the time of day on the clock falls within the cooking start and end times. To correct the setting error, change the cooking time or cooking end time. Cancelling a setting To cancel a setting, press the cooking time button and then press the - button until 00 00 appears on the display. A set programme will automatically cancel on completion. Minute minder A Cooking time Cooking end Manual Subtract time Add time Fig. 5 Setting To set, press and release the desired function, and within 5 seconds set the time with + and - buttons. The + and - buttons increase or decrease the time at a speed depending on how long the button is pressed. Setting the time Press any two buttons (cooking time, end time, minute minder at the same time, and + or - button to set the desired time. This deletes any previously set programme and the AUTO symbol flashes. Manual use By pressing the manual button the AUTO symbol switches off and the saucepan symbol lights up. Manual operation can only be enabled after the automatic programme is over or it has been cancelled. Automatic use Press the cooking time or end time button to switch automatically from the manual to the automatic function. Semi-automatic use with cooking time setting Press the cooking time button and set the desired time with + or -. When the cooking end time corresponds to the time of day, the relay and cooking time symbol switch off, the sound signal rings and the AUTO symbol flashes. When the cooking end time corresponds to the time of day, the relay and the cooking time symbol switch off. When the cooking time is up, the AUTO symbol flashes, the sound signal rings and both the relay and the cooking time button switch off. 8 CARE AND MAINTENANCE Before cleaning the appliance, switch off the electrical supply at the control switch. ENAMELLED SURFACES Clean with a damp sponge using water and mild washing-up liquid. Grease can be easily removed using hot water or a specific cleansing agent for enamelled surfaces. Do not leave any acid or alkaline substances (lemon juice, vinegar, salt, etc. ) on the enamel. Clean the parts in stainless steel with specific cleansers for stainless steel surfaces. PANSTANDS AND BURNERS To clean the burners, remove them by pulling upwards and soak them for about 10 minutes in hot water with a little detergent. 10 935 1000 60 WARNINGS The technical data is indicated on the data plate placed on the rear of the appliance. The adjustment conditions are shown on the label stuck on the packaging and on the appliance. [. . . ] Your cooker must stand on a flat surface so that when it is in position the hob is level. When in position check that the cooker is level by using a spirit level and adjust the 2 feet at the rear and the 2 feet at the front if necessary. It is important that the cooker is stable and level for the overall cooking performance. Remember that the quantity of air necessary for combustion must never be less than 2m3/h for each kW of power (see total power in kW on the appliance data plate). STOP Fig. [. . . ]