User manual ZANKER KRH40GX/1

[. . . ] Otherwise, contact your dealer before proceeding with the installation. The manufacturer disclaims any responsability should all the safety measures not be carried out. Service Centre Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by unexperienced persons may cause injury or serious malfunctioning. Always insist on genuine spare parts. Environmental Information After installation, please dispose of the packaging with due regard to safety and the environment. [. . . ] Use some soapy water, never a flame. Gas connection It is indispensible that the connection to the gas mains are carried out by means of an AGB tap. Choose fixed connections or use a flexible pipe in AGB (stainless steel). If using flexible metallic pipes, be careful they do not come in contact with mobile parts or they are not squeezed. This hob can be operated by Slochteren gas (G25) with a nominal pressure of 25 mbar or by natural gas with nominal pressure of 20 mbar. Before fitting the appliance ensure that the installation has the correct voltage for the appliance. Such a drop in pressure is caused by the following parameters: - maximum capacity of meter; - diameter and lenght of the tube in front and behind the meter; - section of transit of variuos tubes positioned on the circuit; - diameter of eventual connections. FO 2365 A) Ramp with ending nut B) Seal C) Adjustable connection Fig. 4 33 Electrical Connection The appliance is designed to be connected to 230 V monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load (see the rating label); 2) check that the power supply is properly earthed in compliance with the current rules; 3) check the socket or the double pole switch used for the electrical connection can be easily reached with the appliance built in the forniture unit. This has to be provided with a proper plug, able to support the load marked on the identification plate. If connecting the appliance directly to the electric system, it is necessary that you install a double pole switch between the appliance and the electricity supply, with a minimum gap of 3 mm. between the switch contacts and of a type suitable for the required load in compliance with the current rules. The connection cable has to be placed in order that, in each part, it cannot reach a temperature higher than 90°C. The brown coloured phase cable (fitted in the terminal block contact marked with "L") must always be connected to the network phase. Replacement of the voltage cable In case the connection cable needs to be replaced, only cable type H05V2V2-F T90 must be used. The cable section must be suitable to the voltage and the working temperature. 5 34 Adaptation to different types of gas Injectors replacement Remove the pan supports. 6), and replace them with the ones required for the type of gas in use (see table 2). Replace the rating label (placed near the gas supply pipe) with the relevant one for the new type of gas supply. You can find this label in the package of the injectors supplied with the appliance. Fig. 6 FO 0392 Should the feeding gas pressure be different or variable compared with the required pressure, an appropriate pressure adjuster must be fitted on the gas supply pipe, in compliance with the rules in force. Adjustment of minimum level To adjust the minimum level of the burners, proceed as follows: Light the burner. If changing from natural gas to LPG, completely tighten clockwise the screw, until a small regular flame is obtained. Finally check the flame does not go out when quickly turning the knob from the maximum position to the minimum position. [. . . ] 15. These guarantee terms are only valid for appliances purchased and used in Belgium. For exported appliances, the user must first make sure that they satisfy the technical conditions (e. g. : voltage, frequency, installation instructions, type of gas, etc. ) for the country concerned and that they can withstand the local climatic and environmental conditions. For appliances purchased abroad, the user must first ensure that they meet the qualifications required in Belgium. Non-essential or requested adjustments are not covered by the guarantee and are not possible in all cases. [. . . ]