User manual ZANKER KE9000

[. . . ] Best results are achieved when a liquid softener is used in the washer. Do not use heat to dry articles containing foam rubber or similarly textured rubber-like materials, or items containing hair spray, nail polish remover or similar substances. Keep the area around the air intake (toekick) and adjacent surrounding areas free from lint, dust and dirt. The interior of the machine should be cleaned periodically by qualified personnel. [. . . ] To continue drying: ^ Select the new program by pressing the e or - button. ^ Select a dryness level (available in the "Normal" and "Wrinkle-free" programs). ^ Press and release the "Start/Stop T" button to start the new program. Adding or removing laundry during a program ^ Turn off the dryer using the "On/Off" button. ^ Open the door. , CAUTION - Do not touch the rear of the drum while adding or removing items!There is a danger of burns due to high temperatures in the drum. ^ Add or remove items. ^ Turn the dryer back on with the "On/Off" button. 12 Child lock Child lock When activated, the child lock prevents the dryer from being operated by locking the control panel functions. ^ Wipe clean with a soft cloth. 15 Dryer care Emptying the condensed water container Depending on the installation, the condensed water will either be pumped to a drain or collected in the condensed water container, located in the upper left corner of the machine. Should the container be full when the tumble dryer is started, or if it becomes full during normal operation: ­ The "Container" indicator will light. ^ Pull out the container slightly to the right with both hands. ^ Hold the cap open while emptying the container. ^ When the container is empty, push it back into its opening until it clicks into place. Do not drink the condensed water! 16 Dryer care Cleaning the condenser shock, disconnect the dryer from the power supply by shutting off the power main, tripping the circuit breaker or unplugging the power cord before performing maintenance. For items to be left damp for ironing. Note The "Extra Dry" program should not be selected for jersey materials. Items may shrink. More Dry Normal Less Dry Hand Iron Rotary Iron If items are still damp, dry again using "More Dry". If fabrics are too damp, dry again using "Less Dry". For items to be ironed with a rotary iron. For items which require ironing. To prevent moisture loss, roll up the laundry until ready to iron. Wrinkle-free Available drying options Turbo, Gentle, Anti-crease More Dry Normal Less Dry Reduce load size for fabrics that wrinkle easily. Special Programs Available drying options: Anti-crease only available in Fluff, Sturdy Woolens Delicate items which allow machine drying. Take items out immediately after the end of the program while still slightly damp. Allow items to air dry. Smooth Sturdy Fluff - TIMED CYCLES 20 min 30 min Available drying options Gentle, Anti-crease - Frequently asked questions What if the dryer will not run?Add fabric softener to laundry when washing or select the "Less Dry" setting on the dryer. Fix See "Changing the light bulb. " Fix Make sure the dryer is on. Close the door properly. What if the "Child Lock" indicator flashes after turning the dryer on and a program cannot be started?See "Child Lock. " What if the program stops, the "Anti-crease/End" indicator lights and the buzzer sounds?Single items should be dried with "Sturdy" or a timed program and dry items in the "Fluff" program. 21 Frequently asked questions What if the "Filter/Vent" fault indicator is lit?Open a window or door to increase airflow. What if the program runs too long or stops? [. . . ] EASY INSTALLATION KIT If you do not have a dedicated 15 Amp line for this appliance, but you have the standard, 120/208-240 V - 30 Amp, 60 Hz AC outlet, you can use the "Easy Installation Kit", which allows you to use that line to connect the dryer to power. 057B for on-site outlet NEMA 10-30 R 060B for on-site outlet NEMA 14-30 R For more information on the "Easy Installation Kit" or if you have questions concerning the electrical connection, please contact: U V 1-800-999-1360 techserv@mieleusa. com 1-800-565-6435 service@miele. ca 29 Installation Front view a Power cord with plug b Condensed water container c Control panel d Door (with decor option) e Access panel to condenser f Four height adjustable feet g Optional drain hose: An alternative to using the condensed water container is to drain condensed water into a sink, standpipe or gully. 30 Installation Installation site Installation beneath a counter , Do not install the dryer in an area where it can be blocked, e. g. behind a door. Transporting the dryer to the installation site The rear excess end of the lid has a handle box for transport. ^ Use the front dryer feet and the rear excess end to transport the dryer from the packaging base to the installation site. , When the machine lid needs to be removed to reduce the height of the machine, a built under spacer kit* is necessary. [. . . ]