User manual ZANKER AE2050

[. . . ] Objects that melt and things that boil over can burn onto the glass ceramic and should be removed straightaway. Do not use the cooking zones with empty cookware or without cookware. The ventilation gap of 5mm between the worktop and front of the unit underneath it must not be covered. Children's safety Small children must be kept away from the appliance. Only let bigger children work on the appliance under supervision. General safety The appliance may only be installed and connected by trained, registered service engineers. [. . . ] Control panel Switch on the appliance Touch and at the same time Display/Signal l / acoustic signal Until the appliance is next switched off, it can used as normal. Switching the power function on and off The power function makes more power available to the left induction cooking zone, e. g. After that the induction cooking zone automatically switches back to heat setting 9. Control panel Switch on Switch off Touch Touch Touch Display p Power Management The cooking zones have a maximum power available to them. If this power range is exceeded by switching on the power function, Power Management reduces the heat setting of another cooking zone. The display for this cooking zone alternates for two minutes between the set heat setting and the maximum possible heat setting. The time counts down. Displaying the time remaining for a cooking zone Step 1. Control panel field Select cooking zone Display Pilot light of the cooking zone selected flashes faster The time remaining is displayed After a few seconds the pilot light flashes more slowly. Switching off the acoustic signal Step 1. Control panel field Touch Acoustic signal Acoustic signal to acknowledge. Acoustic signal stops. 12 Safety cut-out Cooking surface If after switching on the cooking surface, a heat setting is not set for a cooking zone within approx. by a pan placed upon it, a signal sounds and the cooking surface switches off automatically. If all cooking zones are switched off, the cooking surface automatically switches itself off after approx. a wet cloth) or liquid boiling over onto the control panel immediately switches all cooking zones off. Induction cooking zones In the event of overheating (e. g. Let the cooking zone cool down The highest heat setting has the same power as the automatic warm up function Uncover sensor field The automatic warm up function is There is still residual heat on the not switching itself on cooking zone h The highest heat setting is set Repeated acoustic signal (6x), appliance switches off One or more sensor fields have been covered for longer than 10 seconds Acoustic signal sounds and appli- The On/Off sensor field has been ance switches itself on and then off covered up, e. g. by a cloth again; after 5 seconds another acoustic signal sounds Display is switching between two heat settings Do not place any objects on the control panel Power management is reducing the See the section "Switching the power of this cooking zone power function on and off" Unsuitable cookware No cookware on the cooking zone Use suitable cookware Place cookware on the cooking zone f flashes The diameter of the bottom of the Move onto a smaller cooking zone cookware is too small for the cook- Use suitable cookware ing zone _ is lit e and number are displayed Overheating protection for the cooking zone has been triggered Electronics fault Switch off the cooking zone. Switch the cooking zone on again Disconnect the appliance from the electrical supply for a few minutes (Take the fuse out of the house's wiring system) If after switching on again, e is displayed again, call the customer service department 17 If you are unable to remedy the problem by following the above suggestions, please contact your dealer or the Customer Care Department. 1 Warning!Repairs to the appliance are only to be carried out by qualified service engineers. 3 If the appliance has been wrongly operated, the visit from the customer service technician or dealer may not take place free of charge, even during the warranty period. Considerable danger to the user may result from improper repairs. 18 Disposal 2 Packaging material The packaging materials are environmentally friendly and can be recycled. Please dispose of the packaging materials in the appropriate container at the community waste disposal facilities. 2 Old appliance The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. W 19 Installation Instructions Safety instructions The laws, ordinances, directives and standards in force in the country of use are to be followed (safety regulations, proper recycling in accordance with the regulations, etc. ) Installation may only be carried out by a qualified electrician. Drawers may only be installed with a protective board directly under the appliance. The cut surfaces of the work top are to be protected against moisture using a suitable sealant. When building in, protect the underside of the appliance from steam and moisture, e. g. [. . . ] They will then ensure that the local Service Organisation is aware of your move and able to look after you and your appliances. France Germany Italy Sweden UK Senlis Nrnberg Pordernone Stockholm Slough +33 (0) 3 44 62 20 13 +49 (0) 800 234 7378 +39 (0) 800 11 7511 +46 (0) 20 78 77 50 +44 (0) 1753 219897 Exclusions This guarantee does not cover: Damage or calls resulting from transportation, improper use or neglect, the replacement of any light bulbs or removable parts of glass or plastic. Costs incurred for calls to put right an appliance which is improperly installed or calls to appliances outside the United Kingdom. Appliances found to be in use within a commercial environment, plus those which are subject to rental agreements. [. . . ]