User manual YAESU PEP950 UPDATE V0112 AND V11.53

[. . . ] We recommend using the latest USB adapter driver software when available. Install the data file to PC 1. Down load the FT-950 data file [FT-950_PEP950_11-30-09. zip] from the following website: http://www. yaesu. com/indexVS. cfm?cmd=DisplayProducts&ProdCatID=102&encProdID=292E 02F4E4D00EC99887A63E7B8ECD1B&DivisionID=65&isArchived=0 2. Save the FT-950 data file [FT-950_PEP950_11-30-09. zip] to the desktop on your computer. [. . . ] Please see the DMU-2000 Data Management Operation Manual for the procedure to save your settings to a CF card. 1. Turn the FT-950 OFF and disconnect the DC power cable (or turn OFF the power supply for FT950 and wait a minute, until the capacitors discharge). Locate the program switch thru the access hole on the back at the rear right corner of the radio. Carefully move the PGM-SW to the RIGHT (program position). Carefully move the PGM-SW to the RIGHT (program position). 3. Connect the serial straight through programming cable, DB9F to DB9F, connector to the serial port COM1 in the back of your computer. If you use a USB to serial adapter, you might need to change the COM Port number. Leave the FT-950 turned OFF and connect the DC power cable (or turn ON the power supply for FT-950). Now go to the desktop open PEP950_MAIN folder and find the FSW005 icon as shown below. Double-click the FSW005 icon, displayed on the Program Screen. NOTE: If you receive a "communications error" message on your screen, click on the Configure box and choose a different COM port from the drop down menu. When the program opens, confirm that the file AH031_V0112. SFL is highlighted; if not, click on it to highlight it. When programming has completed, "Confirm" will be displayed. Disconnect the DC power cable (or turn OFF the power supply for FT-950 and wait a minute, until the capacitors discharge) and then remove the DB9 serial programming cable. Thru the access hole on the back of the radio, move the PGM-SW to the LEFT, (operate position). Reconnect the DC power cable (or turn ON the power supply for FT-950). Press and hold in the [FAST] and [LOCK] keys while turning the radio back on. Follow the instructions below to update the EDSP. EDSP This procedure is used for uploading new EDSP Software into the FT-950 Amateur Transceivers, from your personal computer, using the RS-232C, DB9F to DB9F straight cable. Turn the FT-950 OFF and disconnect the DC power cable (or turn OFF the power supply for FT950 and wait a minute, until the capacitors discharge). Connect a serial RS-232C, DB9F to DB9F straight cable to the COM1 connector of your computer and the 9-pin CAT connector on the rear of the transceiver. [. . . ] NOTE: We recommend trying the new factory default settings rather than transferring your old ones, because of the changes in the EDSP and the Main CPU, you may wish to make new settings. The software versions can be displayed on the radio While holding the three buttons [GEN][50][ENT] turn the radio on. The new software versions 11. 53 1. 11 will be displayed in the VFO-A window for 5 seconds, and then the radio will start up in normal operation. EDSP: Software version 11. 53 Main CPU: Software version 0112 We hope this new software will increase your enjoyment of your FT-950. If you have any problems or questions please contact Vertex Standard, Amateur Tech Support. [. . . ]