User manual SMC WHS-POS

[. . . ] Registration can be accomplished via the enclosed product registration card or online via the SMC Web site. The Limited Lifetime warranty covers a product during the Life of that Product, which is defined as the period of time during which the product is an "Active" SMC product. A product is considered to be "Active" while it is listed on the current SMC price list. As new technologies emerge, older technologies become obsolete and SMC will, at its discretion, replace an older product in its product line with one that incorporates these newer technologies. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiated radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: · Reorient or relocate the receiving antenna. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. FCC Caution: To assure continued compliance, (example - use only shielded interface cables when connecting to computer or peripheral devices). Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Industry Canada - Class B This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled "Digital Apparatus, " ICES-003 of Industry Canada. Cet appareil numerique respecte les limites de bruits radioelectriques applicables aux appareils umeriques de Classe B prescrites dans la norme sur le material brouilleur: "Appareils Numeriques, " NMB-003 edictee par l'Industrie. 4 Compliances FCC - Class A This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient the receiving antenna · Increase the separation between the equipment and receiver · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected · Consult the dealer or an experienced radio/TV technician for help EC Conformance Declaration - Class A SMC contact for these products in Europe is: SMC Networks Europe, Edificio Conata II, Calle Fructuós Gelabert 6-8, 2o, 4a, 08970 - Sant Joan Despí, Barcelona, Spain. This information technology equipment complies with the requirements of the Council Directive 89/336/EEC on the Approximation of the laws of the Member States relating to Electromagnetic Compatibility. For the evaluation of the compliance with these Directives, the following standards were applied: RFI Emission: o Limit class A according to EN 55022:1998 + AI:2000 · Limit class A for harmonic current emission according to EN 61000-3-2/2000 · Limitation of voltage fluctuation and flicker in low-voltage supply system according to EN 61000-3-3/1995 + A1: 2001 Immunity: · Product family standard according to EN 55024:1998 + A1: 2001 · Electrostatic Discharge according to EN 61000-4-2:1995 + A1:2001 (Contact Discharge: ±4 kV, Air Discharge: ±8 kV) · Radio-frequency electromagnetic field according to EN 61000-4-3:1995 5 +A1: 2001 (80 - 1000 MHz with 1 kHz AM 80% Modulation: 3 V/m) · Electrical fast transient/burst according to EN 61000-4-4:1995 + A1: 2001 (AC/DC power supply: ±1 kV, Data/Signal lines: ±0. 5 kV) · Surge immunity test according to EN 61000-4-5:1995 + A1: 2001 (AC/DC Line to Line: ±1 kV, AC/DC Line to Earth: ±2 kV) · Immunity to conducted disturbances, Induced by radio-frequency fields: EN 61000-4-6:1996 + A1: 2001 (0. 15 - 80 MHz with 1 kHz AM 80% Modulation: 3 V/m) · Power frequency magnetic field immunity test according to EN 61000-48:1993 + A1: 2001 (1 A/m at frequency 50 Hz) · Voltage dips, short interruptions and voltage variations immunity test according to EN 61000-4-11:1994 + A1: 2001 (>95% Reduction @10 ms, 30% Reduction @500 ms, >95% Reduction @5000 ms) LVD: · EN 60950 (A1/1992; A2/1993; A3/1993; A4/1995; A11/1997) Industry Canada - Class A This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled "Digital Apparatus, " ICES-003 of the Department of Communications. Cet appareil numérique respecte les limites de bruits radioélectriques applicables aux appareils numériques de Classe A prescrites dans la norme sur le matériel brouilleur: "Appareils Numériques, " NMB-003 édictée par le ministère des Communications. Wichtige Sicherheitshinweise (Germany) 1. Die Netzanschlu ßsteckdose soll nahe dem Gerät angebracht und leicht zugänglich sein. [. . . ] Physical Characteristics Print Method Paper Width Effective Print Width Print Speed Print Head Direct thermal 57. 5 mm ± 0. 5 mm 48 mm Approx. 52 mm/sec or 14 lines/sec Print density: 384 dots/line or 8 dots/mm Print dot space: 0. 125 mm Print life: 50 km Overheat suspension protection Dsub 25-pin female connecter 9600 bps, none, 8 bits, 1 stop bit RTS/CTS and Xon/Xoff protocol Dsub 25-pin male connecter 8 bits, BUSY protocol DC 12V/1A, 6-wire RJ-11 socket 740 g (without cable and paper roll) 185 mm (L) x 114 mm (W) x 90 mm (H) Temperature: 0 - 50¢J Humidity: 10 - 80 RH DC 8V/3. 5A Interface (Serial) Interface (Parallel) Cash Drawer Port Net Weight Dimensions Operating Environment Power Input B. Print Paper Type Model Number Parameters 12 x 24 dots, 1. 25 mm (W) x 3. 00 mm (H) ESC/POS Thermal TF50KS-E (Japan Paper Co. Ltd. ) AF50KS-E (JUJO Thermal) Width: 57. 5 ± 0. 5 mm Max diameter: 50 mm Thickness: 53-60 g/m2 13 6. [. . . ]