User manual SINGER STARLETT 6699

[. . . ] 6660/6680/6699 INSTRUCTION MANUAL MANUEL D’INSTRUCTION “IMPORTANT SAFETY INSTRUCTIONS” “When using an electrical appliance, basic safety precautions should always be followed, including the following. ” “DANGER--To reduce the risk of electric shock:” 1. €This sewing machine should never be left unattended when plugged in. Always unplug this sewing machine from the electric outlet immediately after using and before cleaning. [. . . ] N° DU MODÈLE 100 stitch model STITCH POINTS 80 stitch model 60 stitch model WIDTH LARGEUR (mm) 100 stitch model STITCH POINTS 80 stitch model AUTO AUTO MANUAL AUTO MANUEL AUTO MANUEL AUTO AUTO 60 stitch model LENGTH LONGUEUR (mm) LARGO PATTERN No. 5 35 PATTERN NUMBER REFERENCE GUIDE GUIDE DE RÉFÉRENCE DES MOTIFS GUÍA DE REFERENCIA DEL NÚMERO DE PUNTADA 60 stitch model Modèle 60 points Modelo 60 puntadas 80 stitch model Modèle 80 points Modelo 80 puntadas 100 stitch model Modèle 100 points Modelo 100 puntadas 36 STRAIGHT STITCHING POINT DROIT PUNTADA RECTA 100 stitch model : 00 80 stitch model : 00 60 stitch model : 00 Straight stitch is most frequently used for all types of sewing. Pull both threads under the presser foot toward the back of the machine, leaving about 6” (15cm) clear. Place the fabric under the presser foot and lower the presser foot lifter. Turn the hand wheel toward you (counter-clockwise) until the needle enters the fabric. NOTE: The Needle Plate has both Metric and Inch Markings as an aid for guiding your fabric when sewing a seam. First turn the handwheel toward you (counter-clockwise) until the needle is at its highest position. Raise the presser foot, draw materials to the rear and cut off excess thread with the thread cutter located on the bottom of face cover as shown. NOTE: To secure the stitching and avoid raveling, press the reverse stitch switch and sew a few stitches at the start and end of the seam. NOTA: Para asegurar la costura y evitar deshilaches, presione el interruptor de costura 1 A 4 B 2 3 6 C 5 KEEPING SEAMS STRAIGHT To keep the seam straight, use one of the numbered guide lines on the needle plate. 38 HAND-LOOK QUILT STITCH POINT DE MATELASSAGE D'APPARENCE FAIT À LA MAIN PUNTADA DE ACOLCHADO CONTINUA This stitch is designed to look like hand sewing for topstitching and quilting. T h r e a d m a c h i n e w i t h i n v i s i b l e o r lightweight thread the color that matches your fabric. Increase thread tension a little bit at a time until you achieve the desired appearance. nOTE: For a dramatic appearance , experiment with different tension and stitch length combinations. 100 stitch model : 02 80 stitch model : 02 60 stitch model : 02 Ce point est conçu pour ressembler à un point de Esta puntada fue diseñada para que pareciera surpiqûre et de matelassage cousu à la main. INSERTING ZIPPERS AND PIPING Use zipper foot to sew to the right or left of the zipper or close to the cording. 39 INSERTING ZIPPERS To sew down the right side, attach left side of zipper foot to presser foot holder so that the needle passes through the opening on the left side of the foot. PIPING To pipe soft furnishings, cover cord with a bias strip of fabric and pin or tack it to the main piece of fabric. Attach left side of zipper foot to foot holder so that needle passes through the opening on the left side of the foot. Helpful Hint: Slight adjusting of the needle position to sew closer to the piping may be accomplished with the Stitch Width Control. 40 ZIGZAG STITCHING POINT ZIGZAG PUNTADA ZIG-ZAG 100 stitch model : 04 80 stitch model : 03 60 stitch model : 03 Under side Côté de dessous Reverso SETTINGS :Presser foot - General Purpose Foot :Thread tension control - 5 The top thread may appear on the bottom depending on the thread, fabric, type of stitch and sewing speed, but the bobbin thread must never appear on the top of the fabric. If bobbin thread is pulling to the top or you are experiencing puckering, slightly reduce the tension with the Thread Tension Control. [. . . ] * Needle size is not correct for thread and fabric (see page 22 - 23). However, especially when sewing softer leather and suede, better results may be achieved by using the normal zigzag foot. Open zipper by pulling down on the slider and pull tab located at the top of the zipper. Working on the right side of the fabric, baste the zipper face down along the seam edge of the right-hand side of garment. [. . . ]