User manual SINGER COMPACT STEAM PRESS CSP1

[. . . ] Close supervision is necessary for any appliance being used by or near children. Do not leave Compact Steam Press 1 unattended while connected to power supply. When not in use, keep the Pressing Plate and Ironing Board locked together with the Locking Knob. 12. Before Plugging in the Compact Steam Press 1, be high wattage appliance on the same circuit. [. . . ] Using the Water Container, slowly pour up to 2/3 cups (150cc) of water into the Water Tank Fill Hole 'C'. Turning on the Press Check the voltage printed on the bottom of the Press to be sure it is same as your power outlet. Check to make sure the ON/OFF Switch 'A' is in the OFF position by pressing the side of the switch labeled '0'. Unlock the Pressing Plate and Ironing Board by sliding Locking Knob 'B' to the open position. Grasp the Pressing Handle and lift the Pressing Plate to the full open position. Rotate the pressing Plate from storage position to ironing position by pressing the Orientation Change Button 'C'. Rotate the Ironing Board from Storage position to ironing position by pressing the Orientation Change Lever 'D'. Switch on the press by moving the ON/OFF Switch to the ON position by pressing the side of the switch labeled '1'. Temperature Selection Turn the Temperature Control Dial 'A' until the arrow points to the number of dots which correspond to your fabric. If your are unsure of the fiber content of your fabric, try a low setting first and gradually increase until the desired results are obtained. ) After several minutes the Ready Light 'C' will come on. This indicates that the pressing Plate temperature has increased to the selected setting. NOTE: The Pressing Plate must be in the up position until it reaches the selected temperature. If you have decreased the temperature setting, allow the Pressing Plate to cool before pressing. It is for this reason that we recommend pressing fabrics which require low temperatures first (NYLON) and gradually increasing the temperature as needed. 09 MODEL CSP1 5. Steam Control For steam pressing, turn Steam Control 'A' clockwise. The farther the dial is moved in this direction, the more steam will be produced. Your Temperature Control Dial must be in the Steam zone (4 dots or above) to produce steam. NOTE: If this is the first time you are using the Press after filling with water or after a long period of storage, lift the Pressing Plate to the raised position and pump the Burst of Steam Handle several times until steam begins to flow. For dry pressing, turn Steam Control 'A' counterclockwise as far as it will go. 10 MODEL CSP1 6. Pressing Carefully spread the area to be pressed on the Ironing Board removing all unwanted folds. Grasp the Pressing Plate Handle 'A' and lower the Pressing Plate 'B' on to the Ironing Board 'C'. If steam has been selected, it will be pumped into and absorbed by the fabric. [. . . ] Continue with next pleated area until all pleats are pressed. 21 MODEL CSP1 Curtains Rotate the Pressing Plate and Ironing Board through 90 degrees. Other applications These techniques can be used for a multitude of items!Here are just a few suggestions for use of your Compact Steam Press 1: * Household Linens * Garment Construction * Attaching Fusible Interfacing * Dresses (use the pressing Cushion) * Embroidery (place face down on Ironing Board) 22 MODEL CSP1 TROUBLESHOOTING Problem Cause Remedy Turn Locking Knob to open position. Push ON/OFF Switch to OFF (O) position and back to ON (1) to turn Compact Press back on. [. . . ]