User manual SINGER 81-65

[. . . ] Present in the water do not clog the appliance; after performing this operation, screw the inlet hose tightly onto a tap with a ¾ gas threaded connection. €¢ To a suitable hot water connection point: your dishwasher may be provided with hot water from the mains supply (if you have a central heating system with radiators) provided that it does not exceed a temperature of 60°C. Screw the hose to the tap as described for connection to a cold water supply.  If the inlet hose is not long enough, contact a specialist store or an authorised technician (see Assistance ). [. . . ] Open the door and measure out a suitable amount of detergent (see below). Select the wash cycle by pressing the SELECT WASH CYCLE button: the corresponding indicator light will illuminate. Start the cycle by pressing the START/RESET button: the machine will emit a confirmation beep. The WASH CYCLE PHASE indicator lights display the status of the cycle: Pre-wash, Wash, Rinse, or Drying. At the end of the cycle two short beeps will sound and the DRYING indicator light will flash. Switch off the appliance by pressing the ON/OFF button and close the water inlet valve. Open the door and wait for a few minutes before removing the crockery inside, in order to avoid burns. Pour in the detergent after consulting the Wash cycle table: • for powder detergent use compartments A and B • for tablets, use compartment A and the bottom of the appliance, i. When the cycle requires 1 tablet, place it in compartment C A and close the cover; when it requires 2, place the second tablet at the bottom of the appliance. Remove detergent residues from the edges of the compartment and close the cover until it clicks. Modifying the duration of a wash cycle already in progress If a mistake was made during the wash cycle selection process it is possible to change the cycle, provided that it has only just begun:press and hold the START/RESET button for 5 seconds After one long beep and three short beeps, the WASH CYCLE PHASE indicator light will switch off: select the new cycle and switch the machine back on by pressing the START/RESET button. 25 g (A) 5 g (B) Eco 25 ml (A) 5 ml (B) 1 (A) • • 2:25’ 25 g (A) Rapid 25 ml (A) 30' 12' Soak 30 g (A) 30 ml (A) • 1:00’ Half load Note To make it easier to measure out the detergent, it is worth remembering that: 1 tablespoon = 15 grams of powder = approximately 15 ml of liquid 1 teaspoon = 5 grams of powder = approximately 5 ml of liquid 19 Rinse aid and refined salt EN  Only use products that have been specifically designed for dishwashers. ) it is not necessary to add rinse aid; however, we recommend that you add salt, especially if you live in an area where the water is hard or very hard. If you do not add salt or rinse aid, the LOW SALT* and LOW RINSE AID* indicator lights will flash continuously. €¢ if drops of water remain on the crockery or there are limescale marks present after the cycle has finished, set the adjuster to a higher number (4-6).  If you are using multi-functional tablets (2-in-1, 3-in-1, 4-in1, etc. ) and you wish to further improve the drying performance of the appliance, fill the dispenser and set the dosage adjuster to 2. 9 Autonomy (cycles/2 kg) / 60 40 25 10 – 25 18 – 44 25 – 50 45 – 89 > 50 > 89 Loading the refined salt In order to obtain the best possible results from a wash cycle, make sure that the dispenser is never empty. Refined salt removes limescale from the water, thus avoiding the formation of deposits on crockery. The salt dispenser is located in the lower part of the dishwasher (see Description) and should be filled: • when the green float* cannot be seen by simply looking at The default setting of the water softening system is +. ) fill the salt dispenser and set the adjuster to -; if the hardness of the water is greater than 60°fH, set it to +. 20 Care and maintenance Shutting off the water and electricity supplies • Turn off the water tap after every wash cycle to avoid leaks. [. . . ] - if the load is smaller than usual activate the Half load option (see Start-up and use). €¢ If your electricity supply contract gives details of electricity saving time bands, run wash cycles during the periods when a lower tariff is applied. The Delayed start* button (see Start-up and use) helps you organise the wash cycles accordingly. Phosphate-free and chlorine-free detergents containing enzymes • We strongly recommend that you use detergents that do not contain phosphates or chlorine, as these products are harmful to the environment. [. . . ]