User manual SINGER 81-3

[. . . ] Connecting the water inlet hose • To a suitable cold water connection point: before attaching the hose, run the water until it is perfectly clear so that any impurities that may be present in the water do not clog the appliance; after performing this operation, screw the inlet hose tightly onto a tap with a ¾ gas threaded connection. • To a suitable hot water connection point: your dishwasher may be supplied with hot water from the mains supply (if you have a central heating system with radiators) provided that it does not exceed a temperature of 60°C. Screw the hose to the tap as described for connection to a cold water supply. If the inlet hose is not long enough, contact a specialist store or an authorised technician (see Assistance). [. . . ] This option is not recommended for use with wash cycles which do not specify the use of multi-functional tablets (see Table of options). Delayed start It is possible to delay the start time of the cycle for a period of time between 1 and 24 hours. After selecting the desired wash cycle and any other options, press the DELAYED START button. Use the same button to select the time at which you wish the wash cycle to begin (after a period of 1 to 24 hours). Extra drying To improve the dryness level of the crockery, press the EXTRA DRYING button; the indicator light will illuminate. Confirm the selection using the STAR/PAUSE button; the symbol will stop flashing and the countdown will begin. The text “Start in…” will be displayed, the selected delay time will flash and the START/PAUSE button will remain lit in a fixed manner. When the set time has elapsed, a long beep sounds, the DELAYED START indicator light switches off and the wash cycle begins. To deselect the DLEAYED START option, press the DELAYED START button repeatedly until the text OF. The Delayed Start function cannot be set once a wash cycle has been started. SELFCARE WASH CYCLE This disinfecting wash cycle deep cleans the inside of the dishwasher, thereby reducing the formation of bad odours. If using a multi-functional product it is not necessary to add rinse aid; however, we recommend that you add salt, especially if you live in an area where the water is hard or very hard. - Press the DELAYED START button repeatedly until the desired hardness level has been reached; (1-2-3-4-5* see Water hardness table), up to a maximum of five levels. - To exit the function, wait approximately 30 seconds or press another option button, or switch off the machine using the ON/OFF button. Even if using multi-functional tablets, the salt dispenser should still be filled. 1 9 level 1 2 3 4 5* If you do not add salt or rinse aid, the LOW SALT* and LOW RINSE AID* indicator lights remain lit. Measuring out the rinse aid Rinse aid makes it easier for the crockery to dry, as water runs off surfaces more readily and therefore does not leave streaks or marks. The rinse aid dispenser should be filled: • When the LOW RINSE AID* indicator light on the control panel is illuminated; 1. Open the dispenser by turning the lid (G) in an anticlockwise direction. Pour in the rinse aid, making sure it does not overflow from the dispenser. For values between 0°f and 10°f, we do not recommend the use of salt. * this setting may cause a slight increase in the duration of the cycle. [. . . ] • The European Directive 2002/96/EC relating to Waste Electrical and Electronic Equipment (WEEE) states that household appliances should not be disposed of using the normal solid urban waste cycle. Exhausted appliances should be collected separately in order to optimise the cost of re-using and recycling the materials inside the machine, while preventing potential damage to the atmosphere and to public health. The crossed-out dustbin is marked on all products to remind the owner of their obligations regarding separated waste collection. For further information relating to the correct disposal of household appliances, owners may contact the relevant public authority or the local appliance dealer. [. . . ]