User manual SINGER 591V200A

[. . . ] 13) Learn to get to know the parts which make up your dishwasher, you will use it better for it. This is where you will find the description of the controls and the internal parts. 14) This page includes useful tips to help you load your dishwasher correctly and make the most of all the available space. 15) After loading the dishes, you need to select the right wash cycle and measure out the correct dose of detergent and rinse aid. [. . . ] The detergent should be poured into the two containers C and D up to the rim. If you prefer to use the detergent in tablets, place one of these in container "D". B C D Useful tips • Use the right amount of detergent: if you use too much, you will not get cleaner dishes, but just more environmental pollution. • Keep your dishwasher detergent and rinse aid in a cool, dry place and away from children. Check whether there is any detergent residue on the edges of the dispenser. The rinse aid container is situated on the inside of the appliance door; you should refill it when you see the container is empty by means of indicator “D”. (If your dishwasher is fitted with a “low rinse aid” indicator light, fill the container up when the indicator light flashes or lights up). You can adapt the amount of rinse aid used by the dishwasher: regulate the adjuster F which you will find under lid C. If drops of water remain on the dishes or spotting occurs, turn the dosage adjuster to a higher setting. If, on the other hand, the dishes have white streaks, then turn the dosage adjuster down to a lower setting. Warning Three-in-one dishwasher tablets are now available on the market, and combine the detergent, salt and rinse aid all in one. Connect the cold water supply hose to a threaded 3/4 (gas) connector, inserting the small filter supplied with the dishwasher and making sure that it is fastened tightly in place (see figure 2). If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked and damage the appliance. Your dishwasher can be supplied with hot water from the mains supply (if you have a central heating system with radiators) at a temperature of no more than 60°C. In this case, the wash cycle time will be about 15 minutes shorter and the wash will be slightly less effective. The connection must be made to hot water supply following the same procedures as those indicated for the cold water connection. Fit the drain hose into a drain pipe with a minimum diameter of 4 cm or place it over the sink. Use the special plastic elbow provided (see figure) to position it in the best possible way. The free end of the hose should be between 40 and 100 cm above the ground and should not be immersed in water. your dishwasher has arrived Installation and moving D ISHWASHER Electrical connection. First of all, check that the mains voltage and frequency values correspond to those stated on the rating plate located on the stainless steel inner door of the appliance and that the electrical system to which the dishwasher is connected is sized for the maximum current indicated on said rating plate. [. . . ] The entire filter assembly should be cleaned thoroughly once a month: cup C + semi-circular filter A + cylindrical filter B. Reassemble the filter parts (as shown in the figure) and reinsert the whole assembly into the dishwasher. Improper replacement of the filters may reduce the efficiency of the wash and even damage your dishwasher. Food residue may become encrusted onto the sprayer arms and block the holes where water comes out. [. . . ]