User manual SINGER 324

[. . . ] Use this sewing machine only for its intended use as described in this manual. Use only attachments recommended by the manufacturer as contained in this manual. Never operate this sewing machine if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the sewing machine to the nearest authorized dealer or service center for examination, repair, electrical or mechanical adjustment. [. . . ] By pressing the mode button (f), mode will change alternately and it is indicated by highlighted arrow on the right side of LCD. M-1: Single needle setting (Regular setting) m-2: Twin needle setting When you select this mode, it remains until you turn off the machine. Mirror/reverse stitch You can set the mirror stitch, or reverse stitch or mirror/reverse stitch. Pressing the function button directly under this mark, stitch will change alternately or in rotation. Mirror and Reverse stitch If the mark is not indicated, the pattern cannot change to mirror or reverse stitch. O-1: Regular length o-2: Elongated (2 X) If the mark is not indicated, its pattern can not elongate. Straight stitch center needle positon For top stitching, zipper sewing etc. 10, 8:31 PM STRAIGHT STITCH SEWING Straight stitch patterns should be selected to suit the type of fabric being sewn. Hold the upper thread and bobbin thread loosely and press the foot controller pedal to start sewing. When you reach the end of seam, release the pressure on controller and stop sewing. Machine will sew a few stitches backward and sew a few stitches forward and stop automatically. 8, 11 General Purpose Foot Place fabric so that needle will fall nearest to edge of fabric when using the General Purpose Foot. NOTE: You can also cut off the excess material after sewing the inside of fabric. The guide (e) on the blind foot ensures even feeding of the fabric when blind hem stitching. Place fabric so that the straight stitches (or small zigzag stitches) are on the protruding hem edge and the large zigzag stitches just catch one thread of the folded edge (g). Turn the screw so that the guide barely touches the folded edge of fabric. Lower the presser foot and sew hem, guiding fabric evenly along the guide. Place two pieces of fabric right sides together and sew a long straight stitch. Fix applique on fabric with fabric glue, fusible iron-on or basting stitches. Sew edge of applique, while dropping the needle as close to the edge as possible. The straight stitch is almost entirely sinkstitched and a hand-made effect is obtained. When sewing sharp angles Bring needle to lowest position and raise the presser foot. [. . . ] Note: As letter stitches cannot change setting, setting button will not appear. Setting the stitch width and length Machine wil pre-set the stitch width and length suitable for the pattern. Mirror / Reverse stitch Press the mode button and highlight the upper arrow mark on the right side of LCD. Mirror and Reverse stitch Pressing the function button directly below these mark, mark will change alternately or in rotation. [. . . ]