User manual SINGER 212U539A
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SINGER 212U539A. We hope that this SINGER 212U539A user guide will be useful to you.
 |
Manual abstract: user guide SINGER 212U539A
Detailed instructions for use are in the User's Guide.
[. . . ] Unplug immediately.
WARNING To reduce the risk of burns, fire, electrical shock or injury:
1. Supervision is necessary when this machine is used by or near children. Use this sewing machine only for its intended use as described in this manual. Only use attachments recommended by the manufacturer as described in this manual. [. . . ] (The machine needle will not go up and down until you push in the flywheel. )
13
PDFMAILER. DE
Inserting the Bobbin
1
1. Make sure the thread unwinds in the direction shown in the illustration.
2
2. Close bobbin cover.
14
PDFMAILER. DE
Threading the Machine
Turn the flywheel toward you to raise the needle to its highest position. Guide the thread down the right side slot into the tension area, continuing down around the check spring holder.
2
3
3. Firmly pull the thread from right to left, over the take-up lever and down into the take-up lever eye.
4.
Pull the thread down behind the lower thread guide. Thread the needle from front to back.
4 5 6
5.
6.
15
PDFMAILER. DE
1
Drawing Up the Bobbin Thread
1. Raise the presser foot and hold the needle thread lightly with your left hand.
2
2. Continue turning until the needle has risen and the take-up lever is at its highest position. Pull up the needle thread together with a loop of bobbin thread.
3
3. Slide 10 cm (4") of both threads to the back under the presser foot.
16
PDFMAILER. DE
SECTION III
Sewing Basics 1 2
Example Of How To Read the Machine SetUp Information
Set Stitch Selection Knob j Set stitch selection knob on straight stitch. Set Stitch Length Knob k Set stitch length knob according to fabric weight (see page 18).
3 4 5
Set Thread Tension Dial l Set thread tension to 4. Turn zipper face up (right seam allowance forms a small fold at basting line) and smooth zipper teeth away from seam. Starting at the bottom, sew through the folded seam allowance and zipper tape.
20
PDFMAILER. DE
Stop just before the zipper foot reaches the slider on the zipper tape. Lower the foot and stitch the remainder of the seam.
Close the zipper and spread the fabric flat with the right side facing up. Set stitch length to 4 and baste through the opened seam allowance and zipper tape. Reset stitch length to 2. 5.
Move the zipper foot to the left side pin. Guide the edge of foot along the zipper teeth and stitch through the garment and zipper tape. Raise the foot, remove the seamline basting stitches and open the zipper. Lower the foot and stitch the remainder of the seam, making sure the fold is even. Remove remaining basting stitches.
21
PDFMAILER. DE
Pintucks
Pintucks should be added to your fabric before cutting out the pattern piece. Use a washable fabric marker and draw lines for pintucks on the fabric right side. Place folded fabric under presser foot against the blind hem foot guide. [. . . ] The stitch selection knob has been turned while the needle was in the fabric.
Skipped stitches.
1. The needle and/or the thread are not suitable for the fabric being sewn. A stretch needle is not being used for sewing stretch, very fine and synthetic fabrics. The bobbin winder spindle is in the winding position.
9 9 9 10 15 8 15 9 18 4 38
The seam puckers.
The stitches form loops underneath the fabric. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SINGER 212U539A
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SINGER 212U539A will begin.