User manual SINGER 18-27

[. . . ] Before inserting the plug into the electrical socket ensure the following: • The appliance is earthed and the plug is compliant with the law. • The socket can withstand the maximum power of the appliance, which is indicated on the data plate located on the bottom left side of the fridge (e. • The voltage must be in the range between the values indicated on the data plate located on the bottom left side (e. If the socket is incompatible with the plug, ask an authorised technician to replace it (see Assistance). [. . . ] Several functions (SUPER COOL, SUPER FREEZE, ICE PARTY, I CARE) are incompatible with others (HOLIDAY, . ); remember that there is a pre-set order of priority which will help you to use the product in the best possible way. When the Ice Party function has finished, press the ICE PARTY button to stop the corresponding LED from flashing and to silence the sound signal. This flashing and sound signal indicates that the function is complete and that the bottle should be removed from the freezer compartment. Child Lock In order to activate the Child Lock function, the Child Lock button must be pressed for 2 seconds; the activation of the button lock is confirmed by a short beep and the illumination of the corresponding LED. To deactivate the function, press the Child Lock button for 2 seconds; deactivation will be confirmed by a short beep and by the corresponding LED switching off. The FREEZER status bar is also used to indicate an Navigating the display Setting the temperatures: If the product is switched on, the refrigerator and freezer status bars will indicate the temperatures set at that and moment. To change them, simply press the buttons corresponding to the compartment for which you wish to change the set temperature. More specifically, each time one of the buttons is pressed the temperature is increased or decreased by 1°, and the level of cold is adjusted accordingly. The temperature values that may be selected for the refrigerator compartment are +12°C, +7°C, +6°C, +5°C, +4°C, +3°C and +2°C, while the values that may be set for the freezer are -18°C, -19°C, -120°C, 21°C, -22°C, -24°C and -26°C. unusual temperature increase in the freezer compartment (see Troubleshooting). Check that the tray is ompletely empty and fill it with water through the opening provided. Excess water prevents the ice cubes from dispensing (if this happens, wait for the ice to melt and empty the tray). Turn the tray 90°: due to the connected compartments each mould fills with water (see diagram). When the ice has formed (minimum time approximately 8 hours) knock the tray against a hard surface and wet the outside so that the ice cubes come loose and take them out through the opening. GB MAX WATER LEVEL WATER LEVEL MAX WATER LEVEL MAX 19 Maintenance and care Assistance GB Switching the appliance off During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply: 1. Press and hold the ON/OFF button for approximately two seconds, until everything on the display switches off apart from the red LED corresponding to the ON/OFF button. The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you dispose of the appliance it must be separately collected. Consumers should contact their local authority or retailer for information concerning the correct disposal of their old appliance. GB General safety • The appliance was designed for domestic use inside the home and is not intended for commercial or industrial use. • The appliance must be used to store and freeze food products by adults only and according to the instructions in this manual. • The appliance must not be installed outdoors, even in covered areas. [. . . ] • Regularly check the door seals and wipe clean to ensure they are free of debris and to prevent cold air from escaping (see Maintenance). 21 Troubleshooting GB If the appliance does not work, before calling for Assistance (see Assistance), check for a solution from the following list. malfunctions: Possible causes / Solutions: The display is completely switched off. • The plug has not been inserted into the electrical socket, or not far enough to make contact, or there is no power in the house. [. . . ]