User manual SINGER 151W1

[. . . ] I Ceramic Glass Module (only on certain models) L Cooktop Broiler (only on certain models) NOTICE The stainless steel grease pan and the cast-iron grill, located in the burner and grate packing box, must be installed, respectively, below and above the electric heating element so that the element is enclosed between the two. 12 How To Use Your Appliance The position of the corresponding gas burner or electric hot plate (if present) is indicated on each control knob. Choose the most appropriate one for the diameter of the cookware being used. The burner can be regulated with the corresonding control knob by using one of the following settings: • Off High Low To turn on one of the burners, place a lighted match or lighter near the burner, press the knob all the way in and turn in the counter-clockwise direction to the "High" setting. [. . . ] During this initial stage, their protective coating hardens and reaches its maximum resistance. Practical Advise on Using the Broiler Preheat the broiler by turning the knob to 12. Settings 1-8 are recommended for reheating food or for keeping it warm after it has been cooked. In general, cooking vegetables can cause stains which are difficult to remove. D Practical Advice on Using the Electric Hot Plates In order to avoid heat loss and damage to the hot plate, use cookware with a flat bottom the diameter of which is not less than that of the hot plate. For best performance, keep in mind the following: • All types of casseroles can be used on the ceramic glass cooking surface. € Use cookware the diameter of which is at least as large as the cooking area so that all of the heat produced by the heating element is used. This will also increase the life of the pots and of the ceramic glass surface as well. Do not use the same cookware that you use for gas burners because the concentrated heat they produce can deform the bottom of the pot. Therefore, you will not achieve best results when using these pots on the ceramic glass surface. Notice: The glue used to seal the glass surface may leave traces on the appliance. Contact service centers authorized by the manufacturer in the following cases: When in doubt about the condition of the appliance after having removed the packing; - Damage to or replacement of the power supply cord; - In the case of a breakdown or malfunction: ask for original spare parts. Therefore, LPG tanks, whether empty or partially full, must not be installed or stored in rooms or spaces below ground level (cellars, ect. It is also a good idea to keep only the tank currently being used in the room, making sure that it is not near sources of heat (ovens, fireplaces, stoves, etc. ) that could raise the internal temperature of the tank above 50°C. Installation of built-in stove tops The appliance can be installed next to furniture units which are no taller than the top of the cooker hob. The wall in direct contact with the back panel of the cooker must be made of non-flammable material. During operation the back panel of the cooker could reach a temperature of 50°C above room temperature. For proper installation of the cooker, the following precautions must be taken: a) The hob may be located in a kitchen, a kitonen/diner or bed sitting room, but not in a bathroom or shower room. B) The furniture standing next to the unit, that is higher than the working boards, must be placed at least 110mm from the edge of the board. C) The cabinets should be positioned next to the hood at a height of at least 420 mm (Fig. (exclusively for cooking appliances) Directly to the Outside b) The room must also allow for the influx of the air needed for proper combustion. [. . . ] In the latter case, a single pole switch must be placed between the appliance and the mains, with a minimum opening between the contacts of 3 mm in compliance with current safety codes (the earthing wire must not be interrupted by the switch). The power supply cord must be positioned so that it does not reach a temperature in excess of 50°C above room temperature at any point. Before actual connection make sure that: • The fuse and electrical system can withstand the load required by the appliance; • That the electrical supply system is equiped with an efficient earth hook-up according to the norms and regulations prescribed by law; 19 Hook position for Back H=20mm top N. B: Use the hook contained in the "accessoires set" f) In the event the cooktop is not installed above a builtin oven, a wood panel must be inserted as insulation. [. . . ]