User manual SINGER 1116

[. . . ] The sound pressure level under normal operating conditions is 75dB(A). Please turn off the machine or unplug when the machine is not operating properly. If the supply cord that is fixed with foot controller is damaged, it must be replaced by the manufacturer or its service agent or a similar qualified person in order to avoid a hazard. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] - A balanced tension (identical stitches both top and bottom) is usually only desirable for straight stitch construction sewing. - For zig zag and decorative sewing stitch functions, thread tension should generally be less than for straight stitch sewing. - For all decorative sewing you will always obtain a nicer stitch and less fabric puckering when the upper thread appears on the bottom side of your fabric. EN Threading the Upper Thread This is a simple operation but it is important to carry out correctly as by not doing so several sewing problems could result. - Start by raising the needle to its highest point (1), and continue turning the handwheel counterclockwise until the needle just slightly begins to descend. Note: For safety, it is strongly suggested you turn off the power before threading. Place the spool of thread on the holder with the thread coming off the spool as shown. For small thread spools, place small side of spool holder next to spool. (2) - Draw thread from spool through the upper thread guide (3) and pulling thread through pre-tension spring as illustrated. (4) - Thread tension module by leading thread down right channel and up left channel. (5) During this process it is helpful to hold the thread between the spool and thread guide. The length of the individual stitches will increase as the dial approaches "4". Generally speaking, use a longer stitch length when sewing heavier weight fabrics or when using a thicker needle or thread. Use a shorter stitch length when sewing lighter weight fabrics or when using a finer needle or thread. EN Sewing Straight Stitch To begin sewing, set the machine for straight stitch. (1) Place the fabric under the presser foot with the fabric edge lined up with the desired seam guide line on the needle plate. (2) Lower the presser foot lifter, and then step on the foot controller to start sewing. (3) 28 EN Reverse Sewing To secure the beginning and the end of a seam, press down the reverse sewing lever (A). (1) A Removing the Work Turn the handwheel toward you (counterclockwise) to bring the thread take up lever to its highest position, raise the presser foot and remove work behind the needle and presser foot. (2) 1 2 B Cutting the Thread Pull the threads under and behind the presser foot. Guide the threads to the side of the face plate and into thread cutter (B). (3) 30 EN Choosing Stretch Stitch Patterns The stretch stitch patterns are indicated with a blue color on the pattern selector dial. [. . . ] Lower the presser foot aligning the marks on foot with the marks on the fabric (A). Set the machine for straight stitch again, with the width at "0" sew a few securing stitches to finish. if a shank is required , place a darning needle on top of the button and sew. (4) For buttons with 4 holes, sew through the front two holes first, push the work forward and then sew through the back two holes. [. . . ]