User manual SINGER 107W14

[. . . ] Do not operate where aerosol spray products are being used or where oxygen is being administered. To disconnect, turn all controls to the off ("O") position, then remove plug from outlet. The sound pressure level under normal operating conditions is 75dB(A). Always unplug this appliance from the electric outlet immediately after using and before cleaning. [. . . ] B C 1 Attention: Turn power switch to off ("O") before inserting or removing the needle. L'extrémité de l'aiguille est endommagée 23 GB 2 6 3 4 3 4 Threading the upper thread This is a simple operation but it is important to carry out correctly as by not doing so several sewing problems could result. - Start by raising the needle to its highest point (1), and also raise the presser foot to release the tension discs. (2) Note: For safety, it is strongly suggested you turn off the power before threading. Place the spool of thread on the holder with the thread coming off the spool as shown. For small thread spools, place small side of spool holder next to spool. (4) - Guide thread around thread guide (5) pulling thread through pre-tension spring as illustrated. - Thread tension module by leading thread down right channel and up left channel (6). During this process it is helpful to hold the thread between the spool and thread guide (4). - At the top of this movement pass thread from right to left through the slotted eye of the take-up lever and then downwards again. (7) - Now pass thread behind the thin wire needle clamp guide (8) and then down to the needle which should be threaded from front to back. Heavy woollens, overcoat fabrics, upholstery fabrics, some Heavy duty thread, carpet thread. ) NEEDLE, FABRIC, THREAD SELECTION GUIDE NEEDLE SIZE 9-11 (70-80) 11-14 (80-90) 14 (90) 16 (100) 18 (110) IMPORTANT: Match needle size to thread size and weight of fabric. When sewing with twin needles, the stitch width dial should be set at less than "3". Replace needle often (approximately every other garment ) and/ or at first thread breakage or skipped stitches. 36 37 GB a b How to choose your pattern For center needle straight stitch select pattern " " with pattern selector dial. You may choose left needle position, by selecting pattern " ". For zigzag stitch, select pattern " " with pattern selector dial. To obtain any of the other patterns shown on the stitch selection panel, select the stitch with the pattern selector dial. Sélecteur règle-point GB Straight stitching and needle position Turn the stitch selection dial so that the pointer is set to the straight stitch position. Choose your needle position, from center needle position or right needle position. Generally speaking, the thicker the fabric, thread and needle, the longer the stitch should be. [. . . ] Stay stitch along the edge of the area 1/4 of an inch from the edge of the seam. 65 GB 3 Blindstitch applique 2 4 1 - Pattern: Blindhem - Stitch Length: 2 - 3 - Foot: Standard Zigzag or optional Blindhem foot Sewing Instructions: Position applique piece on background fabric and secure it in place using fabric glue. Align needle so that it pierces background fabric along the outside edge of the applique. Using Blindhem stitch, proceed to sew, following the edge of your applique. [. . . ]