User manual SILVERCREST WT 40458 RADIO TRANSMISSION SET

[. . . ] Only insert the adapter plugs (connector power packs) into the labelled DC connection sockets on the respective devices. Make certain that neither the device nor the mains adapter could become wet or damp or sustain any other damage during use. When a storm and/or thunderstorm with the risk of lightening threatens, please disconnect the mains adapter from the mains power. Never allow any fluids to enter into the housing of the radio transmission set. [. . . ] Connector power pack Component integrated into the power plug that converts the power from the building mains to the power (e. Coaxial connector frequently used for audio/video connections, in this case for connecting the radio transmission set to a television. The connector is standardised 21-pin plug that is used between the television set and connected components, for example. The included connector power packs were certified by TÜV Rheinland. First remove all device components from the packaging and remove all packing foil and tape. Important notice: Even when the system (transmitter + receiver) is switched off, the manufacturer still recommends disconnecting the connector power pack from the power network or using a power strip with a shut-off switch. Only this way can it be ensured that the device is completely powered down in the interests of economical use of power. Before starting up the device, please remove the notice from beneath the audio/video antenna. You can transmit video and audio signals from the selected transmission source. Connect the transmitter (e) with a connector power pack (2@) using the 6 V DC connection socket (t). Connect the connector power pack (2@) with a 230 V~/ 50 Hz wall socket. Use the "ON/OFF" switch (r), which is located on the side, to switch on the transmitter (e). The video transmitter (e) is designed so that a sufficiently high output voltage for faultless operation is supplied when simultaneously connected to a source (computer, DVD player, satellite receiver) together with other devices via the included adapter. the local TV switch (i) in the connection panel is then in the "YES" position. If only the video transmitter (e) is connected to the video source, without another device such as a DVD player/ VCR), image disruptions may occur for some device combinations. in this case , set the slider switch (i) to "NO" (= no additional device connected). This lowers the signal power so that the video and sound are transmitted without distortions. Note: If the AV socket of your transmission source is already in use, use the output of the SCART double adapter (1() for the original connection . Connect the receiver to the other connector power pack using the 6 V DC connection socket (j). Use the "ON/OFF" switch (g), which is located on the side, to switch on the receiver (f). If necessary, try positioning the receiver (f) in a different location to avoid interference effects. You can try the following measures to improve the quality in event of transmission disruptions: · Try a different channel, either A, B, C or D. [. . . ] > If you are using other radio devices (same frequency), this may result in disruptions. This device has been both examined and approved in regard to conformity with the fundamental requirements and other relevant regulations of the EMC directive 2004/108/EC and the low voltage directive (LVD) 2006/95/EC. You receive a 3-year warranty for this device as of the purchase date. The device has been manufactured with care and meticulously examined before delivery. [. . . ]