User manual SILVERCREST SLS 1000 A1

[. . . ] Claims of any kind for damage resulting from unintended use will not be accepted. "Made for iPod" and "Made for iPhone" mean that an electronic accessory has been designed to connect specifically to iPod, iPhone, respectively, and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. Please note that the use of this accessory with iPod, iPhone may affect wireless performance. [. . . ] WARNING Damage may occur to property and injuries to people when operating the device!Observe the following safety instructions to avoid dangers: Packaging material should not be used, by children, as a play thing. Charging station SLS 1000 A1 Mains power supply unit NS120P180PGS 12 Plug-in connection cables for 5 V This operating manual NOTICE Check the contents to make sure everything is there and for visible damage. If the contents are not complete or are damaged as a result of defective packaging or through transportation contact the service hotline (see chapter Service). Remove all device parts and these operating instructions from the carton. The packaging materials are selected from the point of view of their environmental friendliness and disposal technology and are therefore recyclable. the recirculation of packaging into the material circuit saves on raw material and reduces generated waste. Dispose of packaging material that is no longer needed according to the regionally established regulations. Connection socket for power supply unit Connection socket for the adapter cable Connection socket for the adapter cable Connection socket for the adapter cable Connection socket for the adapter cable USB port Mains power supply unit Mains power supply unit operation LED Adapter cable Nokia large (MC01) Adapter cable Nokia small (MC28) This data must be compatible to avoid possible damage to the device. Make sure that the mains power supply unit's 8 cable is not damaged and does not run across hot surfaces and/or sharp edges, otherwise it will become damaged. Connect the mains power supply unit 8 to the charging station by inserting the plug into the connection socket 2 on the rear panel of the device. This information can be found in the device's operating instructions. Make sure that the maximum current consumption does not exceed 1000 mA (only when using the USB ports 7 ) and/or 2000 mA. This information can be found in the device's operating instructions. Remove the cover from the charging station and insert the plug of the applicable adapter cable in one of the connection sockets 3 - 6 and/or the iPod/iPhone cable 21 into the USB port 7 . Place the cover back on the charging station thereby feeding the adapter cable through the cut-out on the front panel of the cover. Plug the other end of the adapter cable into the device's power supply socket. if the device has a charge control indicator , this will show that the device is charging. NOTICE The charging station is so efficient that all 4 connection sockets 3 the USB port 7 can be used at the same time. The following table will help with localizing and remedying minor malfunctions: Possible cause The voltage of the device is not compatible with the charging The connected station. [. . . ] In the case of a warranty claim, please make contact by telephone with our Customer Service Department. NOTICE The warranty covers only claims for material and manufacturing defects, but not for transport damage, wearing parts or for damage to fragile components, e. This product is for domestic use only and is not intended for commercial use. The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorised service branch. [. . . ]