User manual SILVERCREST SFS 150 A2 VACUUM SEALER

[. . . ] Ensure that fluids can never permeate into the appliance, whether during cleaning or from the leaking of fluids during the sealing process. Ensure that the power plug is at all times freely accessible, so that in a case of emergency it can be quickly removed from the power source. Ensure that when the appliance is in use the power cable cannot become jammed or damaged in any way. [. . . ] If the control lamp i does not go out after 10 seconds at the latest, the appliance is defective!This is sealed at one end and, at the same time, separated from the roll of tube film. You must leave at least 6 cm of the bag free, measured up to the edge that is to be sealed. Fill the bags in such a way that, under no circumstances, food remnants or fluids can run out of the bag when sealing it and permeate into the appliance. Otherwise, the vacuuming, sealing and cutting will not function properly. If you do not want to extract the air from the bag, you should now seal the last open side. When sealing, you can at the same time extract the air from the bag (vacuuming): Close the appliance cover u and firmly press it down on both sides. As soon as the air has been sucked from the bag, press and hold the Seal/Cut button y with both hands, as already described, and seal the bag. Carefully pull the collector receptacle q out of the appliance using the lateral grips. Clean it in a lukewarm washing-up solution and the allow then collector receptacle q to dry well. Do not wrap the power cable around the appliance, use the guides provided on the bottom of the appliance. Store the appliance where it will be dry and free from dust and particles, so that nothing can lodge in the suction device. Do not use abrasives or detergents, these could damage the plastic surfaces. Do not remove stubborn glue remnants from the sealing wire r with hard or sharp objects, at the very most carefully use a fingernail. Otherwise, the sealing wire r, the cutting wire e or the insulation underneath could be damaged. In the event of malfunction or apparent damage, make contact with Customer Services. First remove the power plug from the wall socket and allow the appliance to cool down completely before cleaning it or placing it into storage. Should food remnants unintentionally be sucked in when vacuuming, the collector receptacle q protects the appliance from damages. [. . . ] Any damage and defects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. Repairs made after the expiration of the warranty period are subject to payment. Enter under "Sender/orderer" your name, address and telephone number (for possible queries) in block capitals. [. . . ]