User manual SILVERCREST SEKU 2000 A1 ELECTRIC FIREPLACE

[. . . ] Compliance with the instructions in this warning is necessary to avoid the risk of death or serious injury. A warning at this danger level indicates a potentially dangerous situation. IMPORTANT A warning of this danger level signifies possible property damage. In addition, artificial fire flares can be created with the appliance to optically replicate an open-hearth fire. [. . . ] Dispose of packaging material that is no longer needed according to the regionally established regulations. If possible preserve the appliance's original packaging during the warranty period so that in the case of a warranty claim you can package the appliance properly for return. For the safe and correct operation of the appliance, the installation site must satisfy the following requirements: Do not place the appliance in a hot, wet or very humid environment or close to inflammable materials. The mains power socket must be easily accessible at all times, thus enabling the plug to be immediately withdrawn should an emergency situation arise. If the heater makes contact with flammable materials, there is a risk of fire!Pay heed to the following safety information to avoid these fire risks: Keep inflammable materials well away from the place of installation of the appliance. Before the first use NOTICE When you first use it, it may temporarily generate a light odour. For a safe and correct operation of the appliance, take note of the following instructions regarding the electrical connection: Before you connect the appliance, compare the connection data (voltage and frequency) on the plate with that of your electricity supplier. Ensure that the power cable is undamaged and that it is not placed over hot surfaces and/or sharp edges. NOTICE The operating elements are on the front of the appliance, above right and behind the ventilation grille. ON/OFF switch (Flames) ON/OFF switch (Heating, level 1) ON/OFF switch (Heating, level 2) Temperature control (Thermostat) Dimmer (for flame lamps) Before the appliance can be set up, the fire surround must be assembled. NOTICE Check the contents to make sure everything is there and for visible damage. Left side panel left front panel top covering panel right front panel centre front panel Base plate Floor plate right side panel You require a screwdriver for the assembly; this is not supplied. Screw three single locking pins Place two wood plugs With a screwdriver into the prepared holes on the left front panel Into the holes of the front panel Insert three adapter sleeves E into the three large holes of the left side panel . Thereby, with the screwdriver line up the adaptor sleeves E so that the arrow on the adaptor sleeves points to the outer edge of the side panel . Then, bring the front panel 2 and side panel together at right angles, so that the locking pins enter the holes on the left edge of the side panel . When done, screw all three adapter sleeves E to the right with the screwdriver until the locking pins are clamped into the adapter sleeves and the panels are seated firmly together and at right angles. Screw three single locking pins Place two wood plugs With a screwdriver into the prepared holes on the right front panel Into the holes of the front panel Insert three adapter sleeves into the three large holes of the right side panel 8 . Thereby, with the screwdriver line up the adaptor sleeves E so that the arrow on the adaptor sleeves points to the outer edge of the side panel 8 . Then, bring the front panel 4 and side panel 8 together at right angles, so that the locking pins enter the holes on the right edge of the side panel. When done, screw all three adapter sleeves E to the right with the screwdriver until the locking pins are clamped into the adapter sleeves and the panels are seated firmly together and at right angles. Take the centre front panel Then place four adapter sleeves E in the four large holes. [. . . ] The complete original declaration of conformity can be obtained from the importer You receive a 3-year warranty for this appliance as of the purchase date. The appliance has been manufactured with care and meticulously examined before delivery. In the case of a warranty claim, please make contact by telephone with our Service Department. NOTICE The warranty is valid only for material or manufacturing defects not, however, for transport damage, wear and tear or for damage to breakable parts, i. [. . . ]