User manual SILVERCREST SDBK 2200 A1

[. . . ] Arrange for defective power plugs and/or cables to be replaced at once by qualified technicians or our Customer Service Department. To disconnect from the power source, pull only on the plug itself, not on the cable. Arrange it in such a way that it cannot come into contact with hot surfaces and so that no-one can step on or trip over it. After every use, before cleaning and when refilling with water, remove the plug from the power socket. [. . . ] Should you wish to secure the steam iron to the station q, for safekeeping for example, slide the unlocking switch 0 with the preplaced steam iron to . In addition to the typical utilisation with a cable, you can also separate the steam iron from the cable base 8 for a short period to iron textiles which are not located close to an electrical power socket. to separate the steam iron from the cable base 8: · Place the steam iron, with the cable base 8 engaged, onto the station q. In a cooled condition, place the steam iron horizontally on its sole e. Using the measuring beaker, fill the water tank with water to the "Max" marking, but no further. Slide the cover of the filler opening for the water tank 2 back to close it. Should the mains water at your locality be rated as hard, it is recommended that you mix mains water with some distilled water. Otherwise, the jets for the steam blast function could calcify (become blocked) prematurely. To extend the optimal steam blast function, mix mains water with distilled water according to the table. As the steam iron cannot be heated up without the cable base 8, you can only work for a short period without the cable base 8. Reconnect the steam iron with the cable base 8 as soon as the steam blast or the ironing quality diminishes. Water hardness very soft / soft medium hard very hard When the set temperature has been reached, the temperature control lamp 6 goes out. Dry ironing without steam is possible at all temperatures, steam ironing is first possible from the adjustment range on the temperature regulator 7. Should the clothing care instructions forbid ironing, (Symbol ), the clothing item may not be ironed. Check the care instructions on the labels in the garment to see if it is suitable for being ironed, and at which temperature setting. The temperature regulator 7 must be turned into at least the adjustment range . The steam blast is especially suitable for smoothing difficult to reach parts of a garment. Place the steam iron only on the cable base 8 or insert it onto the station q. With conventional steam irons it can happen that water drips from the iron sole e at low temperatures. This iron however possesses a new equipment characteristic, the DRIP-STOP function. At low temperatures the iron automatically switches off the steam-blast function. You must then re-set a suitable temperature with the temperature controller 7. [. . . ] This product is for private use only and is not intended for commercial use. The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service branch. Insert the plug into a wall power socket and adjust the temperature regulator 7 to the desired ironing temperature. The warranty period will not be extended by repairs made under warranty. [. . . ]