User manual SILVERCREST SBTF 10 B2

[. . . ] Do not allow children and people subject to supervision play with the appliance, they could injure themselves or cause damage to the appliance. If you wish to connect the appliance to another appliance, read the operating instructions to obtain detailed safety instructions. HF signals can, under circumstances, negatively influence the function of not properly installed or not sufficiently shielded electronic systems in vehicles, e. For further information about your vehicle or its possible ancillaries make contact with the respective manufacturer or their representative. [. . . ] Further information about Bluetooth® radio technology is to be found in the operating instructions for your mobile telephone. Before you can use the hands-free appliance, you must connect it with a compatible mobile telephone (pairing). ⷠCheck to make sure the mobile telephone is switched on. A detailed description of how to do this is to be found in the operating instructions for your mobile telephone. To switch the device off, press and hold the multi-function button 7 for about 3 seconds. A long, low signal tone will be heard and the LED status display 6 extinguishes. ⷠPosition the hands-free appliance and the mobile telephone so that they are not more than 1 metre away from each other. ⷠPress and hold down the multi-function button 7 for 6 seconds until, after 3 seconds a short, high signal tone and after a further 3 seconds a succession of low and high signal tones are heard. The LED status display 6 lights up constantly and the hands-free equipment is now in the coupling mode. Enter in the pre-programmed passcode "9999" and then confirm it, which couples the appliances with each other. You will hear a long high signal tone and the LED status indicator 6 blinks every 3 seconds. When using the latest mobile phones, (Smartphones) those that are equipped with Bluetooth 2. 0 or a more modern version, it is possible that the pass code "9999" need not be entered. If the coupling is not completed within 2 minutes, the hands-free appliance switches itself off. The LED status display 6 extinguishes and you will hear a long and deep signal tone. With some mobile telephones it is possible that coupling does not automatically take place. In this case coupling must be carried out additionally on the mobile telephone. The LED status display 6 blinks twice every 3 seconds until this has been carried out. Further information can be found in your mobile telephone's operating instructions. You can couple the hands-free appliance with up to eight mobile telephones. If a further mobile telephone is coupled with the hands-free appliance, the coupling information of the first coupled mobile telephone is erased. When the hands-free appliance is switched on, within a few seconds it attempts to make a connection to the last used mobile phone. [. . . ] Ensure that the hands-free appliance is distanced a maximum of 10 metres from the mobile telephone and that there are no barriers or electronic devices between them. If these measures do not correct the problem, please contact the appropriate service partner for your country. Before cleaning, always separate the electricity supply from the appliance!Do not use strong detergents, solvents or abrasive cleaning agents to clean the appliance. [. . . ]