User manual SILVERCREST SAS 7.4 LI A1

[. . . ] €¢ Never touch the power supply or the appliance with wet or damp hands. €¢ Do not use the power adapter with an extension cable; connect the power adapter directly to a power socket. To avoid the risk of injury: Intended Usage This cordless hand-held vacuum cleaner may only be used to vacuum dry or wet surfaces resp. Any other usage of, or modification to, the appliance is deemed to be improper usage and carries the risk of serious personal injury. [. . . ] appliance description 1 2 3 4 5 6 7 8 9 0 q Wet suction nozzle Crevice nozzle Wall holder Power adapter Barrel plug On/Off switch Charge indicator lamp Unlocking button Dust filter bag Dust filter Dirt container Note: This appliance is supplied with non-charged batteries. 100 - 240 V ~, 50/60 Hz 200 mA 9, 6 V / 300 mA Ensure that there are no power cables or other conduits or pipes in the wall at the location where you intend to bore the holes for the wall holder 3. It would be a potentially fatal risk to bore into a current carrying electric cable!Place the barrel plug 5 of the power adapter 4 into the wall holder 3 as shown in the diagramme. Before using the cableless hand vacuum cleaner for the first time, the batteries must be charged for at least 24 hours. The batteries reach their full capacity after a charging period of 24 hours. For care of the batteries we recommend the following: after the batteries are charged, remove the power adapter 4 from the mains power socket. Reconnect the power adapter 4 again with the mains power socket when the suction power of the appliance is noticeably weaker. Select a suitable installation location for the wall holder 3: It should present no problem with taking the hand vacuum cleaner out of it and a mains power socket for the power adapter 4 must be accessible. Use the wall holder 3 to mark the boreholes: this will ensure the spacing is correct. Insert the wallplugs into the boreholes and, using the screws, firmly screw the wall holder 3 to the wall. 2012 12:03 Uhr Seite 21 Charging Note: Check to ensure that the on/off switch 6 has been slid back (to the position "0") before starting the charging process. €¢ Place the hand vacuum cleaner from above into the wall holder 3, so that the barrel plug 5 slips into the socket on the hand vacuum cleaner. The charge indicator lamp 7 glows red and the charging process begins. Tips: • Make certain that the dust filter 0 is always inserted before using the appliance. €¢ As the maximum, suck up only as much liquid as will fill the dirt container q to the MAX mark. Take the hand vacuum cleaner from the wall holder 3 or, if you do not use the wall holder 3, remove the barrel plug 5 from the socket. If required, place the appropriate nozzle into the suction opening: • the crevice nozzle 2, to clean narrow and difficult to reach locations. €¢ When the hand vacuum again has enough energy to vacuum, the charge indicator lamp 7 glows green. When the charge indicator lamp 7 glows green, it means the batteries are charged to about 80%. [. . . ] disposal of batteries/cells Used batteries/cells may not be disposed of in household waste. Every consumer is statutorily obliged to dispose of batteries at a collection site of his community/city district or at a retail store. The purpose of this obligation is to ensure that batteries are disposed of in a non-polluting manner. 2012 12:03 Uhr Seite 23 Warranty and Service The warranty for this appliance is for 3 years from the date of purchase. [. . . ]