User manual SILVERCREST SAS 150 A1 ELECTRIC MULTI-PURPOSE SLICER

[. . . ] All other uses, and modifications to the appliance, are deemed to be improper usage and may result in serious physical injury. Supporting table with guide slot Foodstuff carriage Food holder plate with finger guard Cutting blade Food support plate Regulator (Infinite control slice-thickness controller) (Fig. ½ In the event of damage to the power cable 8 , the repair may only be carried out by the manufacturer, his service centre or a suitably qualified specialist. ½ Set up and store the electric MultiPurpose Slicer out of reach of children. [. . . ] Pull to the front for removal of the food carriage 10 from the guide slot 9 and lift it from the support table 9 . Press the pieces of food to be sliced forward using the food holder 11 . Use the slicer only for cutting normal household foods and not for other purposes. Do not use the slicer for cutting deep-frozen foods, bones, foods with large kernels or for the slicing of still packaged foods. The cutting blade 12 continues to rotate for a short while after the slicer has been switched off. For reasons of safety, the slice thickness must be returned to the , , 0" setting after use. Soft foodstuffs: Direct the food carriage 10 slowly against the cutter 12 . Soft foodstuffs, for example hams or cheeses, are best cut when they are at a low temperature / lightly chilled. Hard foodstuffs: With hard foodstuffs you can direct the food carriage 10 somewhat faster against the cutter 12 . You can thus quickly prepare your required amount of of sliced foods, for example salami, bread or gherkins. Low revolutions / Revolution symbol narrow end: Set a low revolution speed when you want to cut soft foodstuffs. high revolutions / Revolution symbol wide end: Use a high revolution speed for slicing hard foodstuffs. Note: Between the maximum and minimum adjustments you can naturally also carry out further individual settings. Note: The two operating modes can be switched on and off with the rocker switch for intermittent / continuous operation 3 . The cutting blade 12 runs without it being necessary to hold the switch in this position. Halting continuous operation: Move the switch for intermittent / continuous operation 3 into the , , 0" position and wait until the cutting blade comes to a complete standstill. intermittent operation (switch for intermittent / continuous operation in position , , II"): Set the switch for intermittent / continuous operation 3 to position , , II". The cutting blade will continue to run for as long as the switch for intermittent / continuous operation is held in this position. Halting intermittent operation: Release the switch for intermittent / continuous operation 3 and wait until the cutting blade comes to a complete standstill. The settings on the scale do not correspond with the slice thickness in mm. For safety reasons the cuttingblade 12 is covered in setting , , 0". If necessary, press the food to be sliced with the food holder plate 11 lightly against the food support 13 . [. . . ] The warranty covers only claims for material and maufacturing defects, but not for transport damage, for wearing parts or for damage to fragile components, e. This product is for private use only and is not intended for commercial use. The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service branch. The warranty period will not be extended by repairs made unter warranty. [. . . ]