User manual SILVERCREST KH 4423

[. . . ] To prevent accidents, keep the appliance in a dry location when not in use. · Under extreme conditions, leaks in the battery cells may occur. In the event that battery fluid comes into contact with skin or eyes, the affected area must be rinsed off with water immediately. Contact a physician. Important safety instructions To avoid potentially fatal electric shocks: · Do not charge or use the appliance outdoors. [. . . ] Secure the barrel plug 5 by turning it. Output voltage : Protection class: appliance Input voltage: Battery: Batteries Capacity: Batteries: 9V 200 mA 7, 2 V 1300 mAh 6 x 1. 2 V Sub-C Ni-MH HR14/HRM 26/50 Information about the batteries 1. Before using the cableless hand vacuum cleaner for the first time, the batteries must be charged for at least 24 hours. The batteries reach their full capacity after a charging period of 24 hours. For care of the batteries we recommend the following: after the batteries are charged, remove the power adapter 4 from the mains power socket. Reconnect the power adapter 4 again with the mains power socket when the suction power of the appliance is noticeably weaker. 2. Select a suitable installation location for the wall holder 3: It should present no problem with taking the hand vacuum cleaner out of it and a mains power socket for the power adapter 4 must be accessible. Use the wall holder 3 to mark the boreholes: this will ensure the spacing is correct. Insert the wallplugs into the boreholes and, using the screws, firmly screw the wall holder 3 to the wall. Connect the power adapter 4 to a mains power socket. -4- Charging Note: Check to ensure that the on/off switch 6 has been slid back (to the position "0") before starting the charging process. · Place the hand vacuum cleaner from above into the wall holder 3 so that the barrel plug 5 slips into the socket on the hand vacuum cleaner. The charge indicator lamp 7 glows red and the charging process begins. Operation Warning: The suction opening must always be open and unblocked. Blockages lead to overheating and damage to the motor. Tips: · Make certain that the dust filter 9 is always inserted before using the appliance. · Only vacuum up enough fluid/rubbish until the dirt container 0 is filled to the MAX marking. Take the hand vacuum cleaner from the wall holder 3 or, if you do not use the wall holder 3, remove the barrel plug 5 from the socket. If required, place the appropriate nozzle into the suction opening: · the crevice nozzle 2, to clean narrow and difficult to reach locations. · the wet suction nozzle 1 to vacuum liquids up. IMPORTANT: · When the charging process is complete, which may take 12 to 15 hours for completely discharged batteries, the device switches over to a trickle charge (maintenance function) automatically. Nevertheless, in order to avoid possible damage to the batteries, do not leave the appliance permanently connected to the power adapter 4. · Reconnect the appliance with the power adapter 4 when the suction power has become noticeably weaker. Note: After you have vacuumed up liquids, immediately clean the dirt container 0. When you have finished using it, slide the on/ off switch 6 to the rear. Place the hand vacuum in the wall holder 3 and start the charging process when the vacuum power has become noticeably weaker. Note: The hand vacuum cleaner can also be charged directly via the power adapter 4. For this, remove the barrel plug 5 with a slight twist from the wall holder 3 and insert it into the socket on the hand vacuum cleaner. -5- Cleaning To achieve the best results, empty the dirt container 0 and clean the dust filter 9 after every use. Disposal Do not dispose of this appliance in your normal domestic waste. This product is subject to the provisions of European Directive 2002/96/EC. [. . . ] In the case of a warranty claim, please make contact by telephone with our service department. The warranty applies only to claims for material and maufacturing defects, not for transport damage, wearing parts or for damage to fragile components, e. g. This product is for private use only and is not intended for commercial applications. In the event of misuse and improper handling, use of force and interference not carried out by our authorized service branch, the warranty will become void. . [. . . ]