User manual SILVERCREST KH 2382

[. . . ] Dear customer, by purchasing the KH 2382 MP3/CD Car Radio you have decided on a quality product from SilverCrest, which, in terms of technology and functionality, meets the most up-to-date development standards. Read the information included here so that you can quickly familiarize yourself with your device and thus make full use of its functions. These operating instructions are a component of the KH 2382 MP3/CD Car Radio (henceforth designated as the device) and supplies you with important information for intended use, safety, installation and connection as well as operation of the device. The operating instructions must be constantly kept available close to the device. [. . . ] To insert the battery and/or change the battery proceed as follows: Pull the battery compartment out of the remote control by pressing the lateral locking device and at the same time pull the battery compartment out. Turn the multi controller in order to switch the EON function on (EON ON) or off (EON OFF). With this setting DSP is switched off when the radio frequency is shown again. Press the MD/LD button to switch between radio reception (frequency indicator), CD/MP3 operation (CD), card slot (SD/MMC), USB port (USB) and audio input (AUX). NOTICE The operating modes CD, SD/MMC and USB can only be accessed when the corresponding medium is inserted. Press repeatedly the DISP button to display successively the following information: Radio station, title + interpret, time of day (will automatically be set with RDS reception), PTY settings (these RDS functions are transmitted by the broadcast institutions in various formats; see also the chapter "Radio functions") and frequencies. NOTICE When you are not receiving any RDS or PTY information, "PS NONE" or "PTY NONE" is shown in the display. To reset the device to its factory default settings, press the RESET button with a pointed object, such as a pen. Reset the device: when operating for the first time, after the cable connection, if not all function buttons are working when an error message appears in the display. Now press the buttons I or I to change the frequency in steps of 0, 05 MHz (USW) and/or 9 kHz (MW) until the desired frequency is set. 3 seconds one of the station buttons 1 to 6 to save the currently set station. A search immediately starts whereby each found station remains for approx. You can search for alternative frequencies of a station so that it will always have optimal reception. In order to playback only the station's regional programme hold down the AF button until the notice REG ON appears in the display. To again playback the national programme hold down the AF button until the notice REG OFF appears in the display. With the help of this function you can search for stations in a designated genre. The following settings are possible: NEWS AFFAIRS INFO SPORT EDUCATE DRAMA CULTURE SCIENCE NOTICE Please note that this information is dependent on the region, the broadcasting corporation and the station. With the station search only stations of the currently selected PTY identification will be considered. Setting the PTY identification Hold down the PTY button and then turn the multi controller to set the individual PTY identification. Station search by PTY identification During the display of a PTY identification if you press briefly the PTY button or the buttons I and/or I a search immediately starts for stations, which correspond to this PTY identification. If no station is found that corresponds to this PTY identification the notice NOT FND appears briefly and then the search ends with the last set station. In the TA mode the device will immediately switch from other stations or operation modes to the radio station, which is currently broadcasting traffic information. [. . . ] Allow the vehicle to air out until the temperature has again dropped to the operational temperature. Defect The radio and/ or the automatic station saving is not functioning Station memory is not functioning Possible cause The antenna cable is not connected correctly. The connection 4 in the ISO block A (Permanent positive) is not connected correctly. the USB port is intended for devices that function according to the USB standard. [. . . ]