User manual SILVERCREST KH 2159

[. . . ] The universal remote control can replace a maximum of ten remote controls. It can only be used for entertainment electronics with infrared receivers. The functions of the universal remote correspond to those of the original remote controls. The manufacturer declines to accept responsibility for damage(s) arising from improper use. Risk of injury through incorrect handling of batteries! Batteries must be handled with special care. [. . . ] Press the down arrow button (6) repeatedly until SEARCH CODES appears in the LCD display (2). TV appears in the LCD display (2). 17 Note: For a television, press the device button TV (4), then continue with step 8. appears in the LCD display (2). Note: The remote control switches the device code every second and sends an infrared signal. To set the time to three seconds, press the CH button (17) twice during the next step. The remote control automatically searches for the device code for your device. Note: The remote control searches the device list in the forward direction. To change the search direction, press "Minus" on the CH button (17). To return to a forward search, press "Plus" on the CH button (17). If your device only partially responds, repeat the steps with the next device code. Manual search Manually search for the device code within the internal list of the remote control. Note: To conclude your input, press the EXIT button (8). Switch on the device for which you would like to program the remote control. Hold the S button (5) pressed until CODE-SETUP appears in the LCD display (2). Press the down arrow button (6) repeatedly until SEARCH CODES appears in the LCD display (2). TV SLEEP SETUP appears in the LCD display (2). TIMER-SETUP overview 5. The minutes value blinks. 21 Note: Select a value between 1 and 90 minutes. After the configured number of minutes elapse, the remote control will switch off the television. Press the EXIT button (8) repeatedly until the standard display appears in the LCD display (2). Note: If no button is pressed for approx. 30 seconds, the message "TIMEOUT" appears in the LCD display (2). Then the standard display is shown automatically. TV SLEEP CLEAR Switching off the SLEEPTIMER function for the television. Hold the S button (5) pressed until CODE-SETUP appears in the LCD display (2). Press the down arrow button (6) repeatedly until TIMERSETUP appears in the LCD display (2). Press the EXIT button (8) repeatedly until the standard display appears in the LCD display (2). Note: If no button is pressed for approx. 30 seconds, the message "TIMEOUT" appears in the LCD display (2). Then the standard display is shown automatically. TIMER SETUP Note: If a timer is already programmed, this must be cleared. [. . . ] Hold the S button (5) pressed until CODE-SETUP appears in the LCD display (2). Press the down arrow button (6) repeatedly until MACRO SETUP appears in the LCD display (2). then SUCCESS appears in the LCD display (2). 28 Maintenance and Cleaning Battery maintenance Memory function The device codes and learned buttons are retained during a battery change. The following are immediately deleted: Time information and the lighting time for the backlight of the LCD display (2). [. . . ]