User manual SILVERCREST KH 9 OIL-FILLED RADIATOR

[. . . ] To disconnect, always pull the plug itself out of the power socket, do not pull on the power cable. Never touch the oil radiator, the power cable or the plug with wet hands. Under no circumstances may the appliance be submersed in fluids or fluids be allowed to permeate the housing. Should liquids enter the housing, unplug the appliance from the power socket immediately and arrange for it to be repaired by a qualified technician. [. . . ] Warning: To avoid an overheating of the oil radiator it may not be covered!1 Control lamp "Power" 2 Heat level switch 3 Thermostat 4 Warm air switch with integrated warm air control lamp 5 Warm air outlet 6 Cold air intake 7 Power cable retainer 8 Mounting bracket 9 Roller rails 0 Wing nuts Lay the power cable in such a way that no one can tread on or trip over it. Use the fold-out page of these instructions to assist you with the assembly. Take the oil radiator and all components from the package and remove all packaging materials. Place the oil radiator, with the base uppermost, on a soft surface, for example a carpet. Place a mounting bracket 8 under the heater element so that the parts with a screw thread project upwards. Lay a roller railer 9 over it, such that the screw threads protrude through the holes. check to ensure that the recesses on the roller railers 9 face outwards. The screw ends projecting from the appliance must reach into the recesses. Screw one wing nut 0 onto each of the threaded ends of the mounting bracket 8 until it is hand tight. Oil Radiator 2 Roller rails 2 Mounting bracket 4 Wing nuts Operating instructions Unwind all of the power cable from the power cable retainer 7. If you wish to switch the appliance off, first place the warm air switch 4 at the position OFF. Next, turn the heat level switch 2 to "0" and then the thermostat 3 to MIN. Ensure that the thermostat 3 and the heat level switch 2 are standing at MIN resp. You can programme this oil radiator so that, if the room temperature falls near to 0°C, it switches itself on and begins to radiate heat automatically: 1. The oil radiator will now switch itself on if the temperature falls near to 0°C. When the temperature rises above 0°C, the oil radiator switches itself off automatically. The oil radiator will switch on and off periodically to maintain the room temperature above 0°C. With the heat level switch 2 you can regulate how quickly the appliance warms up. If you wish to heat it up particularly quickly, select heat level "III", if a slow warming up is preferred, select heat level "I". [. . . ] This product is for private use only and is not intended for commercial use. In the event of misuse and improper handling, use of force and manipulations not carried out by our authorised service centre, the warranty will become void. This product is subject to the provisions of European Directive 2002/96/EC. Dispose of the appliance through an approved disposal centre or at your community waste facility. [. . . ]