User manual SILVERCREST KH 2600 WAKE-UP LIGHT

[. . . ] 15 Playback music from an iPod/iPhone 17 Playback of external audio devices 19 Playback of nature sounds . These operating instructions are a component of the KH 2600 Wake-Up Light (henceforth designated as the device) and they supply you with important information about the intended use, safety and connection as well as operation of the device . The operating instructions must be constantly kept available close to the device. They are to be read and applied by everyone assigned to operate and troubleshoot the device. [. . . ] Before connecting the device, compare the connection data (voltage and frequency) on the rating plate of the device with that of your power supply network. Make sure that the device's connection cable is not damaged and is not laying over hot surfaces and/or sharp edges. By inserting the batteries you can avoid the loss of programmed time of day and alarm wake time in the event of a possible power outage. The batteries make sure that the internal clock continues to run even during a power outage. When power is restored the correct time appears automatically in the display 4 . NOTICE The back-up batteries only save the time of day and the programmed wake time. Make sure that you observe the polarity as depicted in the battery compartment. Close the battery compartment by replacing the access cover, slide back in and allow it to lock into place. Press, with the fingernail, the recess (A) to the right and, at the same time, pull the battery compartment out. In this chapter you receive important information for the handling and operation of the device. NOTICE The /ALARM OFFbutton 20 does not completely disconnect the device from the mains power. To completely disconnect the device from the mains power the mains power cable plug 23 must be pulled from the mains socket. Set, with the I button 11 or the I button 13 , the current time of day hour. Holding down the respective button for more than 2 seconds starts the speed setting. Set, with the I button 11 or the I button 13 , the current time of day minutes. Holding down the respective button for more than 2 seconds starts the speed setting. NOTICE The time of day will revert back to 0:00 o'clock if the device is disconnected from the mains power supply with no back-up batteries inserted or if the back-up batteries are too weak. The set volume level is shown below and to the right in the display 4 . The volume you have selected will also be saved automatically as the volume for the wake function. NOTICE For a good radio reception the wire antenna 24 must be completely uncoiled. Press and hold down the I button 11 or I button 13 for at least two seconds. Press the ALARM1/ALARM2 button or the MEM-/MEM+ button on the remote control to select the desired memory slot between 01 and 20. [. . . ] To end the sleep function before it is automatically ended press the ALARM OFF button 20 or the button on the remote control. Make sure when you are cleaning the device that no moisture gets inside in order to avoid irreparable damage to it. If you do not intend to use the device for an extended period of time disconnect it from the power supply, remove the batteries and store it in a clean, dry location that is not subjected to direct sunlight. This product is subject to the European directive 2002/96/ECWEEE (Waste Electrical and Electronic Equipment). [. . . ]