User manual SILVERCREST KH 2430 USB RECORD PLAYER

[. . . ] In the present operation insructions the following warnings are used: DANGER A warning of this danger level signifies a life threatening dangerous situation. If the dangerous situation is not avoided it can lead to serious injury or death. The directives in this warning are there in order to avoid serious personal injuries or death. WARNING A warning of this danger level signifies a possible dangerous situation. [. . . ] For safe and trouble free operation of the device the setup location must fulfill the following provisions: The device must be placed on a firm, flat and level base. Do not place the device in a hot, wet or very damp environment or in the vicinity of flammable materials. The mains power socket must be easily accessible so that the power cable can be easily disconnected in an emergency. The surface areas of furniture may possibly contain components that could affect the device's rubber feet, softening them. Before initial use The following transportation protections are attached to the device: ­ Plastic band for holding down the pick-up arm ­ Transport screw 9 for securing the turntable ­ Protective cover for the needle ­ Styrofoam blocks ­ Information sheet for the turntable Remove all packaging material and all transport protection from the device. Release the turntable's transport protection by tightening the transport screw 9 . Observe the following electrical connection for safe and failure free operation of the device: Before connecting the device compare the connection data (voltage and frequency) with that on the rating plate of your electric supply. Make sure that the power cable is not damaged and is not laying over hot surfaces and/or sharp edges. You will need a computer with a vacant USB port and with either Windows® XP or Windows® Vista operating system from Microsoft®. NOTE If you connect the device to another USB port the drivers will be installed again. NOTE In these operating instructions only the settings and programme components are described that you will need for recording and converting your records. Further information can be found on the internet under the address http://audacity. The screen image can differ, depending on the display settings, with other operating systems. NOTE If you have switched off the auto start function and the installation process does not start automatically you can start the installation process by double clicking on the file "audacity-win-1. The window for the selection of further installation options is shown. Dll" from the directory "Audacity_for_WIN" on the Audacity programme CD to your computer's hard drive, i. You start the Audacity programme by double clicking on the programme icon on the desktop or by selecting the corresponding input from the start menu. When the programme starts for the first time after installation you will be asked to select the language. NOTE The language setting can be changed any time at a later date in the programme settings. Carry out the following settings in the section "Record": ­ Device: "USB Audio CODEC" ­ Channels: "2 (Stereo)" Select the option "Listen to new tracks during playback" if the record is to be played back simultaneously when recording. The option "USB Audio CODEC" is only available if you have correctly connected the turntable before the programme starts. Pick-up arm security lever Pick-up arm elevating lever Turntable speed selection switch: 33 , 45 or 78 Rev/min Pick-up arm Needle with cartridge USB port LINE-OUT connection cable for connection of an amplifier (Cinch) Mains power connection cable In this chapter you will receive important information for the service and operation of the device. [. . . ] The warranty for this device is for 3 years from the date of purchase. Should you have grounds for complaint, despite our high quality standards, please contact our Service Hotline. In the event that your complaint cannot be resolved over the telephone, you will receive from them a processing number (RMA number) as well as an address to which you can send your device for repair under warranty. in the case of a mail-in shipment please enclose a copy of the purchase receipt (sales slip). [. . . ]