User manual SILVERCREST KH 2356 BLUETOOTH® HEADSET

[. . . ] Should you do so, the safety of the device may be compromised and the warranty becomes void. ⷠDo not allow children and people who require supervision to play with the device, they could injure themselves or cause damage to the device. During long absences or thunderstorms pull the power supply unit out of the power socket. If you wish to connect the device to another device, read the operating instructions to obtain detailed safety instructions. [. . . ] Place the headset and mobile telephone so that they are not more than 1 meter apart. ⷠPress and hold the Multi function button for 8 seconds until you hear a short high signal tone and the LED status indicator lights up with alternating yellow and blue lights. This mobile telephone now becomes the default telephone for the headset. You hear a high double tone and the LED status indicator blinks blue every 3 seconds. If the coupling is not completed within 2 minutes switch the headset off. However, it can only be connected with one mobile telephone at a time. If a further mobile telephone is coupled with the headset, the coupling information of the first coupled mobile telephone is erased. When the headset is switched on, within a few seconds it tries to establish a connection with the default telephone or the last used mobile telephone. If no connection can be established the headset nevertheless remains recognizable to other mobile telephones. To use the headset with a coupled mobile telephone, which is not the default or last used mobile telephone, the connection must be established via the Bluetooth menu of the mobile telephone. When you want to disconnect the mobile telephone from the headset to connect it to, for example, another Bluetooth device: · You must not delete the coupling with the headset in the Bluetooth menu to disconnect the connection. When you want to reconnect the headset with the default and/or the last used mobile telephone: · Make sure that Bluetooth is activated in the mobile telephone and switch the headset on. With the connection of a previously coupled mobile telephone, a pass code need not be entered. You can set up your mobile telephone so that when the headset is switched on a connection with the mobile telephone is automatically established. Further information regarding automatic coupling is to be found in the operating instructions for your mobile telephone. After successful coupling, the following functions are available to you. Some of the described functions are only possible with a mobile telephone that supports the Handsfree Profile (HFP). In this case charge the headset via the power supply unit or the vehicle adapter. ⷠFor redialing of the last number called, press briefly the Multi function button twice whilst in standby mode. For activation of voice dialling, press briefly the Multi function button once whilst in standby mode. After you hear a short, high signal tone you can speak the call number from your mobile telephone's assigned voice abbreviations. Voice dialing is only available with mobile telephones that support this function. [. . . ] Remove the power supply unit from the power socket and/or the vehicle adapter from the cigarrette lighter socket (In vehicle receptical) of the vehicle. Do not use strong detergents, solvents or abrasive cleaning agents to clean the device. This device complies in regard to conformity with the fundamental requirements and other relevent regulations of the vehicle directive 2004/104/EG and the R&TTE directive 99/5/EG. Dispose of the device through an approved disposal centre or at your community waste facility. [. . . ]