User manual SILVERCREST KH 2289 KITCHEN RADIO

[. . . ] 5 ­ 108 MHz The technical capabilities of this device make possible an adjustable frequency range that lies beyond the permitted frequency ranges of 87. In some countries, different national regulations may apply in regard to the assigned radio frequency ranges. Note that information received from transmissions outside the assigned radio frequency ranges may not be exploited, passed on to third parties or otherwise improperly misused. Connect the appliance only to correctly installed and properly earthed power sockets. [. . . ] Push the two retainer lugs on the mounting plate q into the recesses on the lower rear side of the kitchen radio. Firmly press the front part of the mounting plate q down until you hear it engage. To disassemble the mounting plate q, grip the mounting plate q from below with the thumbs and press it forwards and up until it disengages. Secure the wire antenna with a piece of adhesive tape such that it does not hang down. To disassemble the kitchen radio, press the two retaining levers at the rear of the appliance downwards. Replace the mounting plate onto the radio as described in the following section. The back-up batteries ensure that the programmed time, date, alarm time and set SDAs (Special Day Alert) are not erased in the event of a power failure. Pressing and holding the buttons changes the date at intervals of 10 days. If a button is not pressed within 10 seconds, the kitchen radio defaults back to automatic mode. Pressing and holding the buttons changes the date at intervals of 10 days. When you deactivate the year, the SDA alarm will respond on the set date every year. If a button is not pressed within 10 seconds, the kitchen radio defaults back to automatic mode. The back-up batteries must be checked at least once per year and, if necessary, exchanged for new ones. appearing repeatedly in the display is , , PLEASE WAIT FOR SETTING THANKS". When an RDS-Signal is received, the date and time are automatically adjusted. If the time is not correctly displayed, enter in the correct date and time manually as described in the following sections. If a subsequent button is not pressed within ten seconds, the kitchen radio defaults back into automatic mode (the currently set time is displayed). Pressing and holding the buttons changes the time at ten-minute intervals. With the assistance of the automatic update function, the time display of your kitchen radio is automatically updated upon reception of the RDS signal. The time is automatically updated when the appliance is switched on and reception is made from a station transmitting an RDS-Signal. [. . . ] Keep the button UP s pressed down for two seconds: the kitchen radio searches for the station with the next highest frequency. Keep the button DOWN s pressed down for two seconds: the kitchen radio searches for the station with the next lowest frequency. Repeat these steps until you have found a radio station to your liking. Only the next 10 stations will be saved to the memory button that was last pressed. [. . . ]