User manual SILVERCREST KH 2199 PROJECTION ALARM CLOCK

[. . . ] Take note that you may not exploit irregularly received radio services, pass them on to third parties or improperly misuse them. If you do not intend to use the device for an extended period, remove the batteries. In the event of the batteries leaking acids, put on a pair of protective gloves. ⷠClean the battery compartment and the battery contacts with a dry cloth. [. . . ] Insert the three batteries into the battery compartment k, paying heed to the polarity markings shown in the battery compartment k. Ensure that the black textile strip is positioned under the batteries, this will make future battery exchanges easier. Insert the three batteries into the battery compartment k, paying heed to the polarity markings shown in the battery compartment k. ⷠPosition the projection clock such that the projection lens q is directed onto an empty surface. The distance from the projection lens to the projection area (ceiling or wall) must lie between 0, 4 m and 3 m. Connect the external mains adaptor This device can be operated with an external mains adaptor. Please use only mains adaptors that meet these specifications: Input voltage: 230 V ~ 50 Hz Output voltage: DC 3V (+/- 5%) Rated current: min. 300 mA Polarity: Attention: Make certain that the polarity is correct ­ both for the batteries as well as for the mains adaptor. To switch on, turn the volume controller OFF/BUZZ/VOLUME o until an audible »Click« is heard. Using the volume controller OFF/BUZZ/VOLUME o now set the desired sound volume level. To switch off, slide the switch ALARM ON/OFF/AUTO e into the position "OFF". Note: The radio is only switched off when the switch ALARM ON/OFF/AUTO e is at the positions OFF or AUTO. To simply turn the sound volume regulator o to very quiet, until a »Click« is heard, is not sufficient. As soon as you have found a position with good reception from your desired radio station, leave the telescope aerial w in this position. Release the button HOUR j as soon as the desired hours setting is shown in the display i. Release the button MIN h as soon as the desired minutes setting is shown in the display i. Release the button HOUR j as soon as the desired hours setting is shown in the display i. Release the button MIN h as soon as the desired minutes setting is shown in the display i. Using the sound volume controller OFF/BUZZ/VOLUME o now set the desired sound volume level. If you do not touch any other buttons while the alarm is sounding, after about a minute the radio switches itself off. The radio gives its next alarm call on the following day at the programmed time. If you do not touch any other buttons while the alarm is sounding, after about a minute the alarm tone switches itself off. [. . . ] The warranty for this appliance is for 3 years from the date of purchase. The appliance has been manufactured with care and meticulously examined before delivery. In the event of a warranty claim, please make contact by telephone with our Service Department. The warranty covers only claims for material and maufacturing defects, but not for transport damage, for wearing parts or for damage to fragile components, e. [. . . ]