User manual SILVERCREST KH 2130 RADIO SET

[. . . ] Make sure that neither the device nor the mains adapter becomes wet or damp or sustains any other damage during use. When a storm and/or thunderstorm with the risk of lightening threatens, disconnect the mains adapter from the mains power. Never allow any fluids to enter into the housings of the radio transmission sets. 180 g Video signal: 1 Vss Audio signal: 1 Vss (type) Transmission power: 10 mW Open space range: up to 100 m Within enclosed buildings or other locations, transmission disruptions (reflections) may arise that strongly impair the image and sound quality. [. . . ] Putting the device into use First take all device components from the packaging and remove all packing foil and tape. Important notice: Even when the system (transmitter + receiver) is switched off, the manufacturer still recommends disconnecting the wall plug transformer from the mains power or using a power strip with a shut-off switch. Only in this way is complete switch off assured thus contributing to economical consumer attitude. The signal to be transmitted can be selected via a switch on the front panel of the transmitter. Thereby the radio transmission set can transmit the image and sound signals of every device that emits a sound and/or video signal via a suitable connection: · On devices with cinch outputs for the audio and video signals you connect these via one of the supplied CINCH-- 3, 5mm jack cables 2) to the socket "AV IN 1" i on the rear panel of the transmitter q. Note: Observe the colour coding: The white CINCH plug carries the left audio channel signal and belongs in the white CINCH socket. the red CINCH plug carries the right audio channel signal and belongs in the red CINCH socket. The yellow CINCH plug carries the video signal and belongs in the yellow CINCH socket. If required you can connect a second device as well, with the transmitter and for this select the socket "AV IN 2" u. If the signal source of your signal is available via a SCART connection, you can use the supplied SCART-- CINCH adapter "OUT" 2@ between the device and the CINCH--3, 5mm jack cable 2). if you , nevertheless , want to connect the signal source to a TV , connect the TV via the socket "OUTPUT TO TV" y to the transmitter q. For this you can use either one of the supplied CINCH--3, 5mm jack cables 2) or, if both are already occupied, an equivalent cable from your local dealer. Remove the protective foil from one of the supplied adhesive pads and attach the pad to the rounded off side of one of the infrared cable's 2# transmission diodes. Now remove the 2 protective foils from the adhesive pad and attach the transmission diode to the infrared receiver of your signal source. note: Avoid attaching the full length of the transmission diode to the infrared receiver of the signal source. Otherwise it is possible that direct remote control commands will no longer be received. Proceed in the same manner to connect further signal sources and/or other devices that you want to control with the radio transmission set. Insert the cable plug of one of the supplied wall plug transformers 1( into the connection socket for the supply voltage o. Insert the wall plug transformer 1( into a properly connected 230 V~/ 50 Hz mains power socket. You can control the signal source via the remote control even if you are not in the same room. The receiver d picks up the signal and sends it back to the transmitter q which then redirects the signal via the infrared cable 2# to the signal source. You can also transmit the video signal of a computer if the computer's video card has a VIDEO output available. [. . . ] You receive a 3-year warranty for this device as of the purchase date. Should you, in spite of our high quality standards, have grounds for complaint please contact our Service Hotline. In the event that processing of your complaint is not possible by telephone, here you will receive · A processing number (RMA number) as well as · An address to which you can send your device for repair under warranty. in the case of a mail-in shipment please enclose a copy of the purchase receipt (sales slip). [. . . ]