User manual SILVERCREST KH 1602 ELECTRIC GRILL

[. . . ] After use, allow the appliance to cool down completely before cleaning it. Ensure that the appliance stands with a safe and secure positioning. Ensure that the power plug is quickly reachable in case of danger, and also that there is no danger of tripping over the cable. To protect the non-stick coating, do not use metallic tools such as knives, forks etc. [. . . ] The pre-bored holes in the top plate as well as those in the legs must lie opposite each other. Electric Grill Splatter protection shield Thermostat Stand: Storage plate, top plate, 4 legs, 4 leg pads, 8 screws, 8 nuts Q Grill bars w Splatter protection shield e Connection for power cable with thermostat r Catchment pan t Heat-insulated handles y Heating element u Indicator lamp i Thermostat Taking it into use Before taking the table grill into use for the first time clean it as described in the chapter "Cleaning and care". Usage / grilling may only take place with the catchment pan r intended for the purpose. The voltage of the power source must tally with the details given on the rating plate of the appliance. You can also use the grill without the stand: Place the grill on an absolutely level and even surface. Check to ensure that the grill bars q are correctly placed onto the catchment pan r (see Fig. First insert the power cable with thermostat i into the appliance and then connect it to the power source. As soon as the indicator lamp u goes out the grill has reached the adjusted temperature and is ready for use. A good and even heat distribution is assured by the integrated heating element y under the grill q. Cleaning is made easier by the non-stick coating, which prevents the adhesion of grillables. Bear in mind that there needs to be a mains power socket in the close vicinity. You can thus prevent the burning-on of fats falling from the grillables and make the subsequent cleaning of the appliance easier. Insert the three tenons of the splatter protection shield w into the holes provided on one side of the grill bars q. The 4 mounting pegs on the top plate of the stand must encroach into the depressions on the underside of the grill. Subject to the ambient temperature, it can happen that the control lamp u does not go out with the thermostat setting "M". When the grill has warmed up, take hold of it ONLY with the heat-insulated handles t. Level 0 Level 0 - 1 Level 1 - 3 Grill switched off Grill switched on; low temperature Grill switched on; medium temperature (e. Pieces of meat marinated overnight, from for example the shoulder or neck, will be more tender. This will ensure it stays succulent on the inside and does not dry out. The inside of the appliance must be completely dry before it is taken back into use. [. . . ] Should the non -stick coating become damaged, discontinue use of the appliance. Only the grill bars q and the catchment pan r are suitable for cleaning in a dishwasher. Clean the spatter protection shield w in hot soapy water, then dry it off well afterwards. The plug contacts on the grill bars q must be scrupulously dried after cleaning. [. . . ]