User manual SILVERCREST KH 1151 CEILING FAN

[. . . ] Should you do so, appliance safety can no longer be assured and the warranty will become void. This ceiling fan is intended exclusively for use in private households. Observe all information in this installation and operating manual, in particular the safety instructions. 1x Motor in the motor housing 1x Light module with bulb holders 4x Blades 4x Blade holders 4x Fixing plates 4x Fixings 1x Ceiling attachment with covering 2x Extension rod 1x Cover 1x Bulb 60 W G9 Assembly video (SVCD) Operating instructions Do not leave the appliance unattended when in use. [. . . ] Step 2: Slide the mounting, as shown below, to about halfway on the short extension rod 2. The screws that are screwed into the blade mounts q must point downwards on insertion. First tighten both screws evenly and at the same time until hand-tight, then screw them in tightly with the screwdriver. During the following insertion do not damage the bolts in the extension rods 2 and the cable connection piece!Loosen the cover plate e from the covering 1, whereby you press the individual spring balls through the covering 1 and at the same time pull the cover plate e away from the covering 1. Slide the cover 3 downwards, so that the connecting piece is concealed. Push the support upwards over the bolts, thereby ensuring that the safety screw fits into the appropriate recess. Alternatively, determine whether the installation plate e can be fastened to the lower structure of the subceiling (wooden beam or girder) which is capable of bearing more weight, if so, use wood screws. Fix the installation plate e to the ceiling with 2 screws and, if necessary, the plugs. Place the illumination cover 7 on the motor housing 0 then turn it clockwise until it is firmly seated. Firmly screw the blades with the 2 screws with washers, which are screwed into the blade mounts q, onto the motor housing 0 (see Fig. Hang the fan in the installation plate e, making sure that the mounting lines up properly with the notch (see Fig. Slowly turn the fan for a few complete turns in order to check that the blades are correctly installed. If the rotation is not smooth and easy, check the screw attachment of the blades. You must make certain that the electrical connection wire is not under power. The room ceiling and the screw connection must be capable of bearing a weight of at least 28 kg. Failure to follow these instructions presents a life-threatening risk of electric shock!Each pull changes the speed in the following sequence: OFF - fast - medium - slow Switch the light on with the pull-chain 8. If the fan is also to be switched on and off with a separate switch or a circuit breaker, it will start at the last speed set, unless it was switched off using the pull chain 6. the fan turns clockwise: The air flow is directed toward the ceiling. The heated room air is distributed better throughout the room and the accumulation of warm air near the ceiling is prevented. Connect the cable plug Connect the cable plugs of the two PE conductors of the fan with the sockets on the installation plate e. [. . . ] Any damage and defects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. Repairs made after the expiration of the warranty period are subject to payment. The fastening screws cannot be screwed tightly or were turned too far during installation. Replace the screws and nuts Only use screws that match the original screws; contact the manufacturer or retailer for information. [. . . ]