User manual SIEMENS SF24261
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SIEMENS SF24261. We hope that this SIEMENS SF24261 user guide will be useful to you.
You may also download the following manuals related to this product:
SIEMENS SF24261 (2202 ko)
SIEMENS SF24261 (2210 ko)
SIEMENS SF24261 (634 ko)
SIEMENS SF24261 annexe 2 (2206 ko)
Manual abstract: user guide SIEMENS SF24261
Detailed instructions for use are in the User's Guide.
[. . . ] Instructions for Use
en
5600 053
338 (8212)
en
Index
4 6 6 7 8 9 10 Detergents . Filling the special salt container Filling the rinse-aid container Unsuitable dishes . .
en
Safety instructions
Delivery
Immediately check the packaging and dishwasher for any damage which may have been caused in transit. The wooden frames (if fitted) are made of residual wood and are untreated. [. . . ] This same programme will run again if no other programme button 5 is pressed. The programme starts automatically.
End of programme
The programme has ended when a figure appears in the numerical display 3 .
Programme data
The stated programme data are based on standard operating conditions. The values can vary considerably according to: different amounts of dishes temperature of mains water supply pressure of mains water supply ambient temperature fluctuations in mains voltage machine-related factors (e. g. Energy and water consumption is reduced by up to 1/4 when dishes are washed in the upper basket only. Water consumption values are based on a water hardness setting of 4.
Switching the dishwasher OFF
Several minutes after the programme has ended: Set the main switch 1 to OFF. (Does not apply when Aqua-Stop unit has been fitted) Remove dishes, etc. when they have cooled down.
Interrupting the programme
Set main switch 1 to OFF. If the hot water was switched ON or the appliance has already heated up and then the appliance door opened, leave the door ajar for several minutes and then close. In order to continue with the stored programme, set the main switch to ON again.
Aqua sensor *
* on applicable models The Aqua sensor is an optical measuring device which measures the turbidity of the rinsing water. When the Aqua sensor is active, "clean" rinsing water may be transferred into the next rinsing bath and/or the temperature adjusted. If the turbidity is greater, the water is drained and is replaced with fresh water. 4 litres for utensils which are "less" dirty.
15
en
Time delay
You can delay the start of the programme in 1-hour steps up to 19 hours. Press the timer programming button 4 until the digital display 3 jumps to . Keep pressing the timer programming button until the required time is displayed. To delete the timer programming, keep pressing the button until is displayed. You can change your programme selection at any time until the programme starts.
Cancel programme (Reset)
Only when the master switch is ON. Press the A and C buttons simultaneously, and hold them pressed for approx. To restart the dishwasher, set main switch 1 to ON again and select desired programme.
Remaining running time display
When the appliance has started, the expected programme running time is displayed. The programmed running time is affected by the water temperature, the number of dishes, as well as the degree of soiling. If these conditions are changed, the running time (depending on the selected programme) can vary greatly. As the effect is not detected until a programme is running, the time may be longer or shorter than expected.
Changing the programme
It is possible to change the programme within 2 minutes after you have switched the dishwasher on. Should it be necessary to change the programme after this period, the programme cycle that has already been begun (e. g. [. . . ] These will disappear after the first rinse cycle.
Installation
The required installation dimensions can be found in the installation instructions. Using the height-adjustable feet, adjust the appliance until it is level. Ensure that the appliance is standing firmly.
Waste water connection
See the installation instructions for the required connection steps. Using the enclosed parts, connect the waste water hose to the drainage spigot of the siphon. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SIEMENS SF24261
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SIEMENS SF24261 will begin.