User manual SHARP VLNZ50 QUICK START GUIDE
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SHARP VLNZ50. We hope that this SHARP VLNZ50 user guide will be useful to you.
You may also download the following manuals related to this product:
SHARP VLNZ50 OPERATION MANUAL COMPLETE (2941 ko)
Manual abstract: user guide SHARP VLNZ50QUICK START GUIDE
Detailed instructions for use are in the User's Guide.
[. . . ] CAMCORDER QUICK OPERATION GUIDE
Please consult the supplied operation manual for further details on these and other functions of your camcorder.
1
1
Attaching the Battery Pack
Make sure that the Power switch is set to OFF.
2
1 2
Charging the Battery Pack
Make sure that the POWER switch is set to OFF. [. . . ] Close the compartment door by pressing the centre until it clicks into place.
Web-site: www. sharp. co. uk/support Help Line UK:08705 274277, Ireland:(01) 676 0648
VL-NZ50H-Quick 1 02. 2. 15, 11:01 AM
REC
SAVE
Balance your weight on both legs.
Shooting from a high angle
Turn the LCD monitor so that the screen faces downward.
Shooting from a low angle
Turn the LCD monitor so that the screen faces upward.
TINSE 02P03-JKG
BASIC OPERATIONS
5
1 2
Easy Camera Recording
Remove the lens cap. Hold down the Lock button and set the Power switch to CAMERA.
· The picture from the lens now displays. · The camcorder is now ready to record (Recording Standby mode).
6
1
Playback
Hold down the Lock button and set the Power switch to VCR.
To stop playback
Press l.
Lock button
2
Press j (or k) on the Operation button to rewind (or fast forward) the tape to the desired point.
To turn the power off
Set the Power switch to OFF without pressing the Lock button.
Volume Control
Lock button
AU T O
3
Press the REC START/STOP button to begin recording.
RE C
3
Press m to begin playback.
Push the Volume control to the L or + side to increase (1) or decrease (2) the volume. The volume level indicator will appear on the LCD screen during adjustment only. Once the Volume control is released, the volume level indicator will disappear shortly afterwards.
To pause recording
Press the REC START/STOP button again. Recording pauses, and the camcorder enters Recording Standby mode.
Volume control
Zooming in
PAUSE
Push the Power Zoom control to the T (telephoto) side to get a close-up view (1).
Zooming out
Push the Power Zoom control to the W (wide angle) side to get a wide field of view (2).
VOLUME
Decrease
Increase Speaker
To turn the power off
Set the Power switch to OFF without pressing the Lock button.
Power Zoom control
Zooming
Zooming allows you to move visually closer to or farther from a subject without physically changing your position. [. . . ] When using the optical zoom, you can enlarge the subject up to 10K.
Zoom range indicator
W T ZOOM 3
· The zoom range indicator shows you the current zoom setting.
Web-site: www. sharp. co. uk/support Help Line UK:08705 274277, Ireland:(01) 676 0648
VL-NZ50H-Quick 2 02. 2. 15, 11:01 AM [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SHARP VLNZ50
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SHARP VLNZ50 will begin.