User manual SHARP SJ-T690R annexe 1

[. . . ] If using the refrigerator in the space below dimension of the figure, it may cause the temperatures in the unit to rise, loud noise, and failure. Front adjustable 2 Using the two positioned firmlyfeet, ensure that the refrigerator is and level on the floor. Remove the 2 screws of the cabinet lower part, and 3 use these to fit the foot covers. Do not touch the compressor unit or its peripheral parts, as they become extremely hot during operation and the metal edges may cause injury. [. . . ] (Only for SJ-T690R) Do not replace the right utility pocket with that of the left, and medium vice versa. This refrigerator is provided with a indicator of temperature in the refrigerator compartment to allow you to control the average temperature in the coldest zone. (The door pocket positioned at the same height isn't the coldest zone. You can carry out regular checks to ensure the temperature in the coldest zone is correct and, if necessary, adjust the refrigerator temp. To maintain a correct temperature inside the appliance, check that the indicator of temperature is always BLUE. If the indicator of temperature turns WHITE, the temperature is too high; in this case, increase the refrigerator temp. Control setting and wait for 6 hours before checking the indicator of temperature again. As the ambient temperature of the room, the amount of food stored and the frequency of door opening. When fresh food has been introduced or the door has been left open for some time, it is normal for the indicator of temperature to turn WHITE. To maximize the shelf life of perishable food products, ensure that the food is the freshest possible quality. Evenly place the food on the shelves to allow the cooling air to circulate efficiently. Storing hot foods increases the temperature in the unit and increases the risk of food spoilage. Do not block the outlet and inlet of the cool air circulating circuit with foods or containers; otherwise the foods will not be evenly cooled throughout the refrigerator. Food should be properly stored or covered and the air should be removed to seal tightly. To prevent damage to your refrigerator, do not use heavy This may lead to rusting and deterioration of the electrical insulation. To prevent cracking on inside surfaces and plastic components, follow these tips. Some household chemicals may cause damage, so use only diluted washing-up liquid (soapy water). If undiluted detergent is used or soapy water is not wiped off thoroughly, cracking of plastic parts can result. Duty cleansers or solvents (lacquer, paint, polishing powder, benzine, boiled water, etc. If the power supply is disconnected, please wait for at least 5 minutes before re-connecting power. Do not drop objects inside the refrigerator or strike the inner wall. Wash them in warm soapy dishwashing water; rinse in clean water and dry. [. . . ] Attention: If your used electrical or electronic equipment has batteries or accumulators, please dispose of Your product is marked these separately beforehand according to local requirements. By disposing of this product correctly you will help ensure that the waste undergoes the It means that used necessary treatment, recovery and recycling and thus prevent potential negative effects on the electrical and electronic environment and human health which could otherwise arise due to inappropriate waste handling. If you wish to discard this product, please contact your local authorities and ask for the correct There is a separate method of disposal. Collection system for For Switzerland: Used electrical or electronic equipment can be returned free of charge to the these products. [. . . ]