User manual SHARP DW71 OPERATION MANUAL

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SHARP DW71. We hope that this SHARP DW71 user guide will be useful to you.


SHARP DW71 OPERATION MANUAL: Download the complete user guide (1328 Ko)

Manual abstract: user guide SHARP DW71OPERATION MANUAL

Detailed instructions for use are in the User's Guide.

[. . . ] For EU: The crossed-out wheeled bin implies that used batteries should not be put to the general household waste!There is a separate collection system for used batteries, to allow proper treatment and recycling in accordance with legislation. please contact your local authority for details on the collection and recycling schemes. For Switzerland: The used battery is to be returned to the selling point. [. . . ] A burning smell), stop the operation immediately and turn the circuit breaker OFF. â· The appliance shall be installed in accordance with national wiring regulations. Improper cable connection can cause the power supply cord, plug and the electrical outlet to overheat and cause fire. â· If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. Point the remote control towards the receiver window and press the desired button. â· Make sure nothing, such as curtains, block the signal receiver window. â· When replacing the batteries, always change both and use the same type. â· If you will not be using the unit for a long time, remove the batteries from the remote control. â· Use of certain fluorescent lamp in the same room may interfere with transmission of the signal. â· Do not leave the remote control in direct sunlight or near a heater. The red OPERATION lamp ( ) will light and the unit will start operating in the AUTO mode. Timer duration can be set from a minimum half an hour to a maximum of 12 hours. 5 hours, you can set in half-hour increments, and from 10 to 12 hours, in 1-hour increments. When the temperature is set during timer setting, the temperature will show in the display for 5 seconds and then return to the timer display. When the TIMER OFF is set, the temperature setting is automatically adjusted to prevent the room from becoming excessively cold or warm , for example while you sleep. The unit will turn on prior to the set time to allow the room to reach the desired temperature. (The red OPERATION lamp and the orange TIMER lamp cannot be turned off. The blue PLASMACLUSTER lamp and/or ) will the green FULL POWER lamp ( turn off. The built-in protective device may prevent the unit from operating when used at higher temperature than this range. â· Condensation may form on the air outlet if the unit operates continuously in the COOL or DRY mode when humidity is over 80 %. This air conditioner has a memory function to store settings when a power failure occurs. After power recovery, the unit will automatically re-start in the same settings which were active before the power failure, except for timer settings. [. . . ] Carpet and furniture odors that entered into the unit may be sent out from the unit. The unit does not receive the remote control signal â· Check whether the remote control batteries have become old and weak. â· Try to send the signal again with the remote control pointed properly towards the unit's signal receiver window. â· Check whether the remote control batteries are installed properly. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE SHARP DW71




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SHARP DW71 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.