User manual SHARP CDBA1500 OPERATION MANUAL
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SHARP CDBA1500. We hope that this SHARP CDBA1500 user guide will be useful to you.
You may also download the following manuals related to this product:
SHARP CDBA1500 QUICK START GUIDE (168 ko)
SHARP CDBA1500 OPERATION MANUAL PART (FROM SERVICE MANUAL) (56 ko)
Manual abstract: user guide SHARP CDBA1500OPERATION MANUAL
Detailed instructions for use are in the User's Guide.
[. . . ] When the 12-hour display is selected, "AM" will change automatically to "PM".
0. 2 m - 6 m (8" - 20')
Notes concerning use: Replace the batteries if the operating distance is reduced or if the operation becomes erratic. [. . . ] Periodically clean the transmitter LED on the remote control and the sensor on the main unit with a soft cloth. Exposing the sensor on the main unit to strong light may interfere with operation. Keep the remote control away from moisture, excessive heat, shock, and vibrations.
7
Press the MEMORY/SET button.
TUNING/TIME ( )
or ) button to adjust
1
RESETTING THE MICROCOMPUTER
Press the ON/STAND-BY button to enter the standby mode.
8
Press the TUNING/TIME ( the minutes.
2
Press the CLOCK button.
3
ON/ STAND-BY EQUALIZER X-BASS/ DEMO
Within 5 seconds, press the MEMORY/SET button.
Press the TUNING/TIME ( or ) button once to advance the time by 1 minute. (Seconds are not displayed. ) And then the clock display will disappear after a few seconds.
0:00
AM 0:00
AM 12:00
To see the time display: Press the CLOCK button. The time display will appear for about 5 seconds.
"0:00"
The 24-hour display will appear.
(0:00 - 23:59)
"AM 0:00"
The 12-hour display will appear.
(AM 0:00 - PM 11:59)
Note: The clock display will flash on and off at the push of the CLOCK button when the AC power supply is restored after a power failure occurs or after the AC power lead is disconnected. If this happens, follow the procedure below to change the clock time.
"AM 12:00"
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
Note that this can only be set when the unit is first installed or it has been reset.
To change the clock time: 1 Press the CLOCK button. [. . . ] If this happens, follow the procedure below to change the clock time.
"AM 12:00"
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
Note that this can only be set when the unit is first installed or it has been reset.
To change the clock time: 1 Press the CLOCK button. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SHARP CDBA1500
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SHARP CDBA1500 will begin.