User manual SHARP AL-800

[. . . ] To aid in reporting this compact copier in case of loss or theft, please record below the model number and serial number located on the back of the unit. We also suggest you record all the information listed and retain for future reference. USER PROGRAMS (power save modes, auto clear time) Setting the power save modes and auto clear time Original table and original cover Cleaning the drum cartridge When copier is not in use This chapter provides basic information for using the copier. This copier has been designed to provide intuitive operating ease while requiring a minimum amount of space. [. . . ] Put the drum cartridge down on a clean, uncluttered and level surface. Roll it tightly so that the diameter of the hole at each end is less than the thickness of your little finger. Gently rub the surface of the drum (green portion) with the rolled-up paper to remove any particles of toner caking on the drum. Do not let the drum surface come into contact with anything other than the rolled-up paper. When copier is not in use Remove the power cord and the interface cable (AL-840 only) and secure the copier using tape (two locations). If this copier is not in use for a long time, remove the copy paper from the paper tray and store it in a location that is not humid. If the copy paper is left in the paper tray for a long time, it will absorb moisture, resulting in paper misfeeds. When the misfeed ( ) indicator blinks or blinks in the display, the copier will stop because of a misfeed. Remove the misfed paper following the instructions for each location shown in the illustration below. Pull the paper release lever at the right of the paper tray toward you. Remove all the paper, including the jammed paper, from the paper tray. If the misfed paper will not come out easily, do not pull it hard, as you may tear it or damage the printing mechanism. Straighten the edges of the stack of paper and then reinsert it into the paper tray. Gently pull the TD cartridge out and place it on the scrap paper which was prepared in step 1. Take a piece of scrap paper that is larger than the drum cartridge and fold it in half. Keep this paper ready to shield the light-sensitive part of the drum cartridge from light after it is removed from the copier. The paper to be used for placing the TD cartridge and drum cartridge may become soiled due to toner, etc. The paper for placing the drum cartridge must be large enough to cover the surface of the cartridge (green portion) when folded in half. Gently pull the drum cartridge out and wrap the removed drum cartridge in the paper which was prepared in step 4 so that the green drum section is shielded from light. do not touch the surface of the drum (green portion) of the drum cartridge. Remove the misfed paper by grasping the end of the paper nearest you and pulling it gently in a straight line. Remove the misfed paper from the exit area by grasping the end of the paper and pulling it gently in a straight line. [. . . ] Upon repair of your unit, Sharp will promptly return it at no cost to you at any U. What You Must Do Your Product is designed to perform with a minimum amount of user maintenance. However, you are responsible for the required user maintenance described in the Operation Manual. This requires user maintenance including replacement of the TD cartridge and drum cartridge, cleaning of the unit and transfer charger, removal of dust and foreign matter, clearing of paper misfeeds, and proper routine and preventive maintenance. [. . . ]