Detailed instructions for use are in the User's Guide.
[. . . ] mars 2004 1:57 13
INTRODUCTION
Dear customer: Thank you for purchasing a SAGEM DECT telephone; we appreciate your trust in us. This product was manufactured with the utmost care, should you encounter any difficulties during its use, we recommend that you refer to this user guide. You can also find information on the following site: http://www. sagem. com/faq For your comfort and safety, we ask that you read the following paragraph carefully:
Recommendations and safety instructions
Your DECT telephone must not be installed in a humid room (wash room, bathroom, laundry room, kitchen, etc. ) unless it is 1. 50 m away from a water point, or outside. Your telephone must be operated at temperatures ranging from 5°C to 45°C. [. . . ] · To transfer a single number, take the sender handset and proceed as follows: - Select the number to be transferred using or . Once it is done, a screen indicating the end of the transfer will appear.
03/150 Candy OK
Smith
Harris
Transfer
Return
47
Livre du MD+. book Page 48 Mercredi, 31. mars 2004 1:57 13
INTERCOMMUNICATION
·
03/150 Candy OK
If you have elected to transfer numerous numbers, take the sender handset and proceed as follows: - Select one of the numbers to be transferred in the phonebook using or . Once it is done, you are taken back to the list of numbers in the phonebook. - Select the next number to be transferred using or and press Transfer . Press Return
R
Smith
Harris
Transfer
Return
to exit.
Monitoring a room
You can use your handset to monitor a room. The other handset will remain with you, it is in "receiver" mode. On the receiver handset: On the navigator key , press or until the Internal call screen is
displayed, press OK to confirm.
Internal call
Transm. PhBk OK Room monitor Internal call
Return Confirm
Select Room monitor using
or
. Press Confirm
.
Room monitor
OK Handset 2 Handset 3
Return Call
Select the sender handset using
or
. .
The sender handset rings, pick up using the green key
48
Livre du MD+. book Page 49 Mercredi, 31. mars 2004 1:57 13
INTERCOMMUNICATION
On the receiver handset: A screen invites you to activate the monitor mode (sender mode). The handset in sender mode does not ring to notify you of incoming calls. At the end of the call, the handset will automatically return in monitor mode. - Press Stop Stop
R R
Monitor mode -Sender Stop
Monitor mode -ReceiverStop Call
on the receiver set and confirm by pressing Yes
and
on the transmitter handset at the same time.
49
Livre du MD+. book Page 50 Mercredi, 31. mars 2004 1:57 13
SECURITY SECURITY
This menu enables you to change or customise the security parameters of your telephone. You can: · lock the keypad, · programme an emergency number, · modify the base code, · define the call time limit, · define forbidden prefixes, · authorise or deny communication to a number of handsets, · hide your telephone number.
Security
Return Confirm
Locking/unlocking the keypad
To lock/unlock the keypad, press and hold the keypad key some time. On the navigator key , press Confirm or until the Security for
screen is displayed, press OK to confirm.
Security
Confidential OK Keypad lock Emergency
Return Confirm
Select Keypad lock using Press Confirm
or
.
to lock the keypad.
A screen indicates that the keypad is locked.
Keypad locked Long press on * for unlock
Programming an emergency number
This function allows you to define an emergency number which can be enabled or disabled. Once it is activated, the emergency number will be automatically dialled when the green key · is pressed from the idle screen. Once activated, you can however call a different number with predialling by dialling a number and pressing
50
Livre du MD+. book Page 51 Mercredi, 31. mars 2004 1:57 13
SECURITY
The following types of numbers should not be programmed: Fire, emergency and police rescue services. . .
On the navigator key
, press
or
until the Security screen is
displayed, press OK to confirm.
Security
Keypad lock OK Emergency Change Code
Return Confirm
Select Emergency using
or
. Press Confirm
.
Emergency
Phone No: Off
Edit Confirm
An information screen displays the current stored emergency number and indicates whether it is enabled or disabled. .
To keep the setting, press Confirm
Emergency
Activate OK Enter number Deactivate
Return Confirm
A list offers you to either change the status (on/off) or modify the emergency number.
Emergency
Emergency no. [. . . ] avril 2004 10:06 10
WARRANTY
1) Defects breakdown or malfunctions due to: · failure to properly follow the installation process, the operating manual and/or the instructions for use; or · an external cause to the Equipment (including but not limited to, shock, lightening, fire, vandalism, malevolent action, contacts with various liquids or vermin or water damage of any nature, inappropriate electric voltage); or · modifications to the Equipment made without the written approval of SAGEM; or · a lack of every day maintenance (as described in the documentation supplied with the Equipment) or to a lack of supervision or care; or · bad storage or environmental conditions, particularly those related to temperature and hygrometry, effects of variations of electric voltage, parasites from the electric network or from the earth; or · repair, work (opening or attempt to open the Equipment), alteration, tampering or maintenance of the Equipment by persons not authorised by SAGEM. 2) Damage due to insufficient or bad packaging of Equipment when returned to the Authorised Repair Centre. 3) Wear and tear from normal daily use of the Equipment and its accessories. 4) Communication problems related to an unsuitable environment, including in particular: · problems related to access to the telephone network such as interruptions by access networks or malfunction of the line used by the subscriber or his correspondent, poor line telephone quality, · transmission faults (for example, poor geographical coverage by radio transmitter line quality, or any interference between the environment and the radio transmitter), · modifications of parameters of telephone network carried out after the sale of the Equipment. [. . . ]